Armodilo Xero Start Here

Adding your tablet
F
F
A
C
B
F
F
G
E
Adding the tablet
E
D E
01 Set the tablet into the corner tabs
02 Combine A , B and optionally C
aligning the edges together on all sides
03 Align the combined parts over the
corner tab E holes
04 Insert pins in locations shown to temporarily
X 3
hold the combined parts in place
F
05 Thread 4x into E to secure
the two front pieces over the tablet Step #4
starting with the two holes without pins
The kickstand
The Xero tablet holder was designed to work with a kickstand if used
* The corner tabs E are attached
on it's own to provide the perfect viewing angle. The kickstand comes
to G at the factory. Please do not
remove these or adjustments may standard with solo Xero purchases and can be purchased as an add-on
be necessary (See Tablet Alignment).
when purchasing a Xero stand combo. It works in either landscape or
portrait mode and can easily be reconfigured, simply follow these steps:
1. Gently squeeze the kickstand from the sides to
compress it slightly towards the center of the Xero
2. The kickstand, once squeezed can be removed
and reoriented into another set of mounting holes
D 3. Align one side of the kickstand into a set of mounting
holes. Gently squeeze to compress the kickstand
E
and get the other side into place.
Do not over compress the kickstand or permanant damage may occur.
Insert temporary pins into locations
shown during setup to help hold the
various pieces in place
while assembling
start here
Cleaning & care
Your Xero tablet holder is made of various parts which may require
cleaning from time to time. Please dissasemble and remove the
tablet before using any liquids to clean the holder.
Clean using a slightly damp, lint free cloth (a mild dish soap and water
solution can be used to dampen cloth). Lightly wipe any surface to
remove dust or dirt. Do not apply too much pressure when wiping
to prevent scratching of the acrylic parts.
CAUTION: Never clean acrylic parts using alcohol or solvents as
they can destroy the acrylic and cause it to crack.
Tablet alignment
The corner tabs that hold the tablet in place are designed to be
E
adjustable and can be turned. Very slight adjustments of these tabs
ensure a perfect tablet fit. If for whatever reason your tablet no
longer sits perfectly, please follow these steps:
1. A set of lines along the side of each corner tab is added
at time of production to indicate proper alignment.
(Shown in red for sample purposes only.)
2. Check to ensure the corner tabs all line up with these
indicator marks. They should be parallel to each other.
3. If they do not, loosen the rear screw on the 'X' backer
and realign the tab back to the indicator mark.
4. Retighten to align the tab positioning.
In the box
A x 1 B x 1
Xero Front Face Xero Front Face Backer
x 1 x 4
G E
Xero 'X' Backer Corner Tabs
(attached to G)
Optional stands & stand hardware
Tilt Sphere Surface Curve
E E
✓ ✘
Properly Requires
aligned adjustment
C Optional
Printed Insert
x 4 (+2 spare) Screws
F
x 1 Driver
ArmoLock Screws & Driver
Floor 3-in-1