Advertisement
4.2.
COUPLINGS
Vibration may cause failure if a quick change coupling is connected directly to the wrench. To overcome this, connect a leader hose to
the wrench. A quick change coupling may then be used to connect the leader hose to the air line recoil hose. See fig.1 & fig.2.
fig.1
5. OPERATION
WARNING! Ensure you read, understand and apply safety instructions before use.
5.1.
Only use impact sockets which are specifically designed for use with an impact wrench.
5.2.
Connect the wrench to the air hose as in section 4.
5.3.
Place the socket fully over the subject nut and depress the trigger to operate the wrench.
5.4.
To change direction, turn the air regulator on the rear of the body to the desired direction and torque (fig.3).
DO NOT use any additional force upon the wrench in order to remove a nut.
DO NOT allow the wrench to free run for an extended period of time as this will reduce bearing life.
6. MAINTENANCE
WARNING! Disconnect the wrench from the air supply before changing accessories, servicing or performing maintenance.
Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
6.1.
If the air system does not have an oiler, lubricate the air wrench daily with a few drops of Sealey air tool oil dripped into the air inlet.
6.2.
Clean the wrench after use with a mild detergent on a moist cloth.
6.3.
For a full service contact your local Sealey service agent.
6.4.
When not in use, disconnect from the air supply, store in a safe, dry, childproof location.
7. TROUBLESHOOTING
7.1.
Loss of power or erratic action may be due to the following:
a) Excessive drain on the air line. Moisture or restriction in the air pipe. Incorrect size or type of hose connectors. To remedy check the
air supply and follow instructions in section 3.
b) Grit or gum deposits in the wrench may also reduce performance. This may be evident in the air strainer located in the area of the
air inlet. Flush the wrench out with gum solvent oil or an equal mixture of SAE No 10 oil and paraffin. Allow to dry before use.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
© Jack Sealey Limited
fig.3
01284 703534
sales@sealey.co.uk
Original Language Version
Original Language Version
fig.2
www.sealey.co.uk
GSA6006
GSA6006
Issue:3 (HF) - 21/12/17
Issue:3 (HF) - 21/12/17
Advertisement
