Subscribe to Our Youtube Channel
Related Manuals for Spearhead HD250F
Summary of Contents for Spearhead HD250F
- Page 1 8999123: v1 18/06/2018 DESTROYER FLAIL HD250F Page 1.1 of 1.10 pages Original instructions (ENGLISH) Website: www.spearheadmachinery.com...
- Page 2 The information given throughout this manual is correct at the time of publication. However, in the course of constant development of Spearhead machines, changes in specification are inevitable. Should you find the information given in this book to be at variance with the machine in your possession, you are advised to contact the Spearhead Service department where up-to-date information will be provided.
- Page 3 8999123: v1 18/06/2018 This machine is produced by ZANON S.R.L. on behalf of Spearhead Machinery Limited. EC DECLARATION OF CONFORMITY Conforming to EU Directive 2006/42/EC-2000/14/EC Of ZANON S.r.l., vIA Madonnetta, 30. 35011 Campodarsego (Padova) - Italy. Declare with our exclusive responsibility that the interchangeable equipment to be coupled with an agricultural...
- Page 4 It is also important to follow that which is described in this manual since Spearhead declines any liability resulting from negligence of from not observing these norms, since it would result in the warranty being annulled.
-
Page 5: Table Of Contents
8999123: v1 18/06/2018 Contents List Machine Description ..........................7 Intended Usage ......................... 7 1.1.1 Allowed Uses ....................... 7 1.1.2 Improper Uses ......................7 General Arrangement ....................... 8 Identification ..........................9 Machine general specification....................9 Sound Level ..........................9 EC marking of the flail mulcher ....................10 Safety .............................. - Page 6 8999123: v1 18/06/2018 Page 1.6 of 1.10 pages Original instructions (ENGLISH) Website: www.spearheadmachinery.com...
-
Page 7: Machine Description
DANGER! Spearhead declines any and all liability for damages caused by the flail mulcher to persons, animals or property, resulting from use other than that described in this manual, or due to damage caused by negligence or by not observing the instructions contained in this manual. -
Page 8: General Arrangement
8999123: v1 18/06/2018 General Arrangement With reference to Figure 1.2, the mulcher is a machine designed and built exclusively for mulching operations directly on the field. It shreds plant remains, allowing you to mulch branches, overgrown vegetation and logs. It must not be used for other uses or with other materials. -
Page 9: Identification
Tractor Connection Standard hydraulic outlets Notes: (1) Spearhead constantly reviews and improves product designs and reserve the right to change this information. Actual machines may vary from the above specification. Contact your Spearhead Sales representative if you have any queries. -
Page 10: Ec Marking Of The Flail Mulcher
(particularly dangerous machinery). In order to certify the conformity of the machine with the provisions of Directive 2006/42/EC, before placing the product on the market, Spearhead applied the procedure described in Art. 5. In this sense, the manufacturer has provided for: compliance with the relevant safety requirements; availability of the technical file as stipulated in Annex VI;... -
Page 11: Safety
- even severe - to people or animals. Spearhead declines all responsibility for damage caused by not complying with the safety and injury prevention regulations described below. Spearhead also declines any responsibility for damage caused by improper use of the machine and/or as a result of modifications made without authorisation by the manufacturer. -
Page 12: Safety Decals
8999123: v1 18/06/2018 Safety Decals The flail mulcher is equipped with safety decals warning about residual risks present on the machine that were not possible to eliminate. Figure 2.1 specifies the meaning of symbols contained in the decals. The operator must memorise the meaning of these decals. - Page 13 8999123: v1 18/06/2018 Read the use and maintenance manual Risk of cutting off feet. with care prior to starting up the machine. Keep at a safe distance. Do not remove protections before halting and disconnecting the machine. Always disconnect the machine from the Risk of cutting off hands.
- Page 14 8999123: v1 18/06/2018 Figure 2.2 shows an indication of the precise points on the machine where the safety decals and serial plate are usually applied by the manufacturer. Figure 2.2 Page 2.4 of 2.7 pages Original instructions (ENGLISH) Website: www.spearheadmachinery.com...
-
Page 15: Personal Protective Equipment
8999123: v1 18/06/2018 Personal Protective Equipment In general it is necessary to wear suitable clothing for the work to be carried out. In particular, as far as flail mulching use, obey the following provisions: - It is mandatory to use clothing which is as suitable as possible, meaning not too loose and without any protruding or moving parts (for example ties or necklaces). -
Page 16: Safe Use
8999123: v1 18/06/2018 Safe use - It is prohibited to use the flail mulcher in ways that are different from the indications contained in Section 1.1 “Intended use”. - It is prohibited to use or have the flail mulcher used by anyone who has not read and completely understood the information contained in this manual. -
Page 17: Safe Maintenance
8999123: v1 18/06/2018 - It is mandatory to comply with the laws in force in the country of installation on the use and disposal of products used for cleaning and performing maintenance on the machine, considering the recommendations of the manufacturer of the given products. -
Page 19: Machine Preparation
After transportation, remove the protection film and check that the machine was not damaged in any way. Spearhead cannot be held responsible for any damage caused by handling carried out any differently from that described in the manual. -
Page 20: First Use
DANGER! Spearhead cannot be held liable for damage to persons, animals or property, caused by non- compliance with the safety and accident prevention regulations or operations which do not conform to the information provided in the user and installation instructions. - Page 21 8999123: v1 18/06/2018 Figure 3.2 3.2.2.4 Verify that the protection rotates freely and secure it with the appropriate chain. Remove the support from the PTO shaft. 3.2.2.5 Connect the headstock top link (C), securing it with the appropriate pins and split pins, and use the tractor adjustable top link to adjust correctly, making sure that the upper surface of the flail mulcher is parallel to the ground.
-
Page 22: Pto Shaft
3.2.3 PTO shaft It is mandatory to only use the PTO shaft supplied as standard by Spearhead, shown in Figure 3.4. Spearhead assumes no liability if a PTO shaft other than the one supplied is used. DANGER! A PTO shaft applied to a tractor is a mechanical part, which, when operating, can be extremely dangerous for those using it. -
Page 23: Usage Instructions
8999123: v1 18/06/2018 Usage Instructions Before use Prior to starting up the flail mulcher, carry out the following operations; 4.1.1. Check that all the screws and nuts are fastened, especially those that secure the teeth; 4.1.2. Check that the PTO shaft is inserted correctly between the gearbox and the tractor PTO and also check the operation of the hydraulic pump and the distributor. -
Page 24: Adjustment Of Working Height
8999123: v1 18/06/2018 WARNING! To carry out these operations the P.T.O. must be disconnected. The tractor must be braked and off. 4.2.1.1. Place the machine on a level surface with two spacers of approx. 12 cm set inside the machine at the rotor ends. -
Page 25: Using The Flail Mulcher
Widia teeth. Constantly check that there are no persons or animals within the operating range of the flail mulcher see Figure 4.4. WARNING! Spearhead declines any and all liability for damages caused by the flail mulcher to persons, animals or property, resulting from use other than that described in this manual, or due to damage caused by negligence or by not observing the instructions contained in this manual. -
Page 26: After Use
8999123: v1 18/06/2018 Figure 4.4 WARNING! Pay the utmost attention to the shape and arrangement of the logs to avoid cutting trees that might hit the operator when they fall. Figure 4.5 After use A few guidelines must be complied with when the work is complete; in order to make sure the flail mulcher is stable when released from the tractor: 4.4.4.1 Move to the storage area of the flail mulcher, making sure that the supporting surface is flat and free from obstructing material. -
Page 27: Safety Devices
8999123: v1 18/06/2018 Store the equipment, preferably in a covered area, on a suitable and flat surface. Follow the instructions given in Section 2.5.2 “Preparation for storage” in this manual. Safety devices There are safety devices in the flail mulcher to safeguard the operator. WARNING! The safety devices must not be tampered or excluded. -
Page 29: Maintenance
8999123: v1 18/06/2018 Maintenance Routine maintenance operations are listed below. Extraordinary maintenance operations (repairs of parts or components) can be carried out by specialised personnel authorised by the manufacturer. WARNING! The schedule is for information purposes only and depends on normal operation conditions. Conditions can in fact change depending on the service, the environment and on frequency of use. -
Page 30: Maintenance On The Widia Teeth
5.1.1 Maintenance on the Widia Teeth WARNING! Spearhead is not liable for damage caused by the vibrations generated by mulching rotors that are not balanced after replacing the Widia teeth. Any requests for replacement under warranty or reimbursement for damage caused due to the rotors malfunctioning will not be accepted. -
Page 31: Belt Maintenance
8999123: v1 18/06/2018 The quality and integrity of the mulcher and its safety depend on the how the Widia teeth are cared for. They must be replaced immediately when damaged. Normal wear is exceeded and accentuated when operating on sandy terrains or if the mulcher is positioned too low and frequently bumps against any obstacles, which can lead to distortions or cracks in the Widia teeth. -
Page 32: Cleaning The Flail Mulcher
8999123: v1 18/06/2018 Figure 5.2 Cleaning the flail mulcher DANGER! This operation is extremely hazardous so the following instructions must be followed. - Wear protective gloves and shut off the thermal engine of the agricultural tractor, subsequently disconnecting the PTO shaft;... - Page 33 8999123: v1 18/06/2018 Figure 5.3 Page 5.5 of 5.5 pages Original instructions (ENGLISH) Website: www.spearheadmachinery.com...
-
Page 35: Troubleshooting
Worn or broken teeth Replace the teeth Deformation of the rotor due to Replace the rotor. Contact the foreign bodies having hit the Spearhead service centre central part Roller support bearing seizure No oil lubrication Verify oil level Page 6.1 of 6.1 pages Original instructions (ENGLISH) Website: www.spearheadmachinery.com... -
Page 37: Spare Parts
For routine maintenance or repair spare parts may be obtained from the Spearhead parts department. To obtain correct part numbers; refer to the Spearhead interactive on-line parts book. This is available at dealerinside.spearheadmachinery.com/partsmanuals/manual.aspx. You will need to enter the machine serial number. -
Page 39: Warranty Information
12 months, unless a different period is specified. All spare parts supplied by Spearhead and purchased by the end user are warranted to be free from defects in material and workmanship from the date of sale to the original purchaser for a period of 6 months. All parts warranty claims must be supported by a copy of the failed part invoice to the end user. -
Page 40: 8.1.3 Remedies And Procedures
Any fault must be reported to an authorised Spearhead dealer as soon as it occurs. Continued use of a machine, after a fault has occurred, can result in further component failure for which Spearhead cannot be held liable. -
Page 41: How To Make A Claim
In the event of a warranty claim being made, the process of making a claim will be carried out entirely by your selling agent. This is an arrangement that exists between Spearhead Ltd and its agents. All claims will be made via the Spearhead web site. - Page 42 8999123: v1 18/06/2018 Page 9.2 of 9.1 pages Original instructions (ENGLISH) Website: www.spearheadmachinery.com...
Need help?
Do you have a question about the HD250F and is the answer not in the manual?
Questions and answers