Fastening To The Built-In Cabinet - Smeg SI2631D Manual

only be possible to remove the double-layer
base using suitable equipment.
1 Opens on bottom
2 Opens on back
A min. 5 mm
B min., 20 mm
C min. 30 mm - max. 50 mm
D min. 30 mm - max. 50 mm
Failure to install the double-layer
wooden base exposes the user to
possible accidental contact with sharp
or hot parts.

Fastening to the built-in cabinet

There are two fastening options depending on
the configuration of the unit in which the
appliance will be installed:
1 Through the side screws.
2 Through the front and rear screws.
To fasten the hob:
1. Unscrew the screws from the holes shown in
the following figures, according to the
fastening option chosen.
34 - INSTALLATION
2. Fasten the fixing brackets (A) into the holes
marked using the screws that were removed
in order to correctly fix the hob to the
structure.
If tightened too much the glass may be
strained and crack.
The fixing brackets should be installed differently
according to the thickness of the countertop.
• Countertop thickness 30 mm:
• Countertop thickness 40 mm:
91477A308/A