natus OLYMPIC CFM 6000 Operator's Manual page 38

Figure 15
Place the drawer into its cavity on the CFM cart (see Figure 16):
4
a
b
c
Figure 16
With the slides fully extended, place
the drawer down onto the slides.
Secure the CFM's power cord to the CFM cart:
5
a
b
c
d
32
Placing the CFM 6000 on its cart
Fully extend the slides.
Place the drawer down onto the slides.
Slide the drawer into position. An audible click indicates that the drawer is
locked into position. Confirm that the detent lever secures the drawer on both
slides (see Figure 16).
Installing the drawer
Plug the power cord into the power receptacle on the back of the CFM 6000.
Unscrew the thumbscrew on the back of the drawer on the CFM cart (see
Figure 17). Select a cord clamp — small diameter for a European power cord, or
larger diameter for a North American power cord.
Place the appropriate cord clamp on your power cord, and then tighten the
thumbscrew.
Wrap any excess power cord around the cord cleats on the back of the drawer
(see Figure 17).
OLYMPIC CFM 6000 Operator's Manual
First, place the CFM 6000 on the
top of the drawer enclosure,
visually aligning the device to the
thumbscrews.
Each slide locks in position in three
locations and an audible click
sounds.
Next, incrementally tighten
the thumbscrews in a
circular or X-pattern.