natus OLYMPIC CFM 6000 Operator's Manual page 37

Figure 13 Securing the foot pedal
Carefully turn the stand over, leveraging the handle and the base.
5
To place the CFM 6000 on its cart:
Remove the drawer from the CFM cart:
1
Open the drawer.
a
Lift the detent levers on both sides of the drawer slides as you lift the drawer up
b
and off the slides (see Figure 14).
Figure 14 Removing the drawer
Remove the tape securing the thumbscrews, and ensure that the thumbscrew spacers
2
are not resting on the threads. The spacers should spin freely.
If the thumbscrew spacers rest on the threads, they act as a jam nut, preventing secure
placement of the CFM 6000 on the cart.
NOTE
Place the CFM 6000 on the top of the drawer enclosure, visually aligning the device
3
to the thumbscrews (see Figure 15). The thumbscrew heads are located inside the
drawer cavity. To maintain balance, tighten the thumbscrews incrementally in a
circular or X-pattern.
Lift the detent levers on both
sides of the drawer as you lift
the drawer up, off the slides.
OLYMPIC CFM 6000 Operator's Manual 31