Page 1
Поставщик систем безопасности TELECAMERA.RU Wireless Curtain PIR Detector V1.0.0...
Page 2
Поставщик систем безопасности TELECAMERA.RU This product is an indoor wireless PIR curtain detector which outputs alarm signal when someone intrudes armed zone and uploads it to wireless alarm controller via wireless module to generate alarm. Applicable model: ARD1611-W...
Поставщик систем безопасности TELECAMERA.RU Table of Contents Important Safeguards and Warnings ..............4 Before Use ......................1 Product Appearance ....................2 Product Features ....................3 Detectable Range ....................4 Device Installation....................5 Use of Product ......................7 Appendix 1 Technical Specifications ................8...
Поставщик систем безопасности TELECAMERA.RU Important Safeguards and Warnings Please read the following safeguards and warnings carefully before using the product in order to avoid damages and losses. Note: Do not expose the device to lampblack, steam or dust. Otherwise it may cause fire or electric shock.
Поставщик систем безопасности TELECAMERA.RU Before Use Do not touch surface of the detector and the lens, so as not to affect the sensitivity of the detector. If you need to clean the detector and the lens, please turn off the power and use a soft cloth dipping some water to do so.
Поставщик систем безопасности TELECAMERA.RU Detectable Range The detector has a detectable range, the top view is in Figure 5- 1.Detection angle is horizontal 15° . Figure 5- 1 The side view of detectable range is in Figure 5- 2. Max detectable distance is 10 meters and min detectable distance is 1 meter.
Поставщик систем безопасности TELECAMERA.RU Device Installation Warning: Installation and debugging must be executed by professional staff. If you encounter device failure, please do not open and repair the device, you shall contact its after-sales department. Avoid installation in environment under direct sunlight. ...
Page 10
Поставщик систем безопасности TELECAMERA.RU Figure 6- 2...
Поставщик систем безопасности TELECAMERA.RU Use of Product LED Setup You can set LED jumper stitch to control LED indicator. Indicator have two mode: ON and OFF. You can set two shifts at position of jumper stitch: 1&2(P1) and 2&3(P2), select P1 as LED-OFF and P2 as LED-ON.
Поставщик систем безопасности TELECAMERA.RU Appendix 1 Technical Specifications Parameter Note Detection Method Dual element PIR Detectable Range 10m,15° Alarm Prompt Red LED, may set OFF Sensitivity Two levels(jumper cap) Carrier Frequency 433MHz Transmission Power 10dBm Transmission 1km(open space/no interference) Distance Anti-visible Light 6500LUX Vandal-proof...
Need help?
Do you have a question about the ARD1611-W and is the answer not in the manual?
Questions and answers