Table of Contents
Advertisement
Parameter
SD Dump Options
AC Power Loss Options
I2C Configuration Options
Uart Configuration Options
ESPI Configuration Options
eMMC Options
Description
Press [Enter] for more options.
SD Configuration Mode
Š
– Select SD Mode.
– Options available: SD Dump disabled/SD Dump Enabled. Default
setting is SD Dump disabled.
Press [Enter] for more options.
AC Loss Control
Š
– Select AC Loss Control Method.
– Options available: Power Off/Power On/Last State. Default setting
is Last State.
Press [Enter] for more options.
I2C 0/1/2/3/4/5 Enable
Š
– Enable or disable I2C 0/1/2/3/4/5.
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
Press [Enter] for more options.
Uart 0 Enable
Š
– Uart 0 has no HW FC if Uart 2 is enabled.
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
Uart 1 Enable
Š
– Uart 1 has no HW FC if Uart 3 is enabled.
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
Uart 2 Enable (no HW FC)
Š
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
Uart 3 Enable (no HW FC)
Š
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
Press [Enter] for more options.
ESPI Enable
Š
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
Press [Enter] for more options.
eMMC/SD Configure
Š
– Options available: Disabled/SD Normal Speed/SD High Speed/SD
UHSI-SDR50/SD UHSI-DDR50/SDUHSI-SDR104/eMMC Emmc
Backward Compatibility/eMMC High Speed SDR/eMMC High
Speed DDR/eMMC HS200/eMMCHS400/eMMC HS300/Auto.
Default setting is Auto.
Driver Type
Š
– BIOS will select MS driver for SD selections.
– Options available: AMD eMMC Driver/MS Driver/Auto. Default
setting is Auto.
D3 Cold Support
Š
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
eMMC Boot
Š
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
- 97 -
BIOS Setup
Advertisement
Table of Contents
