Table of Contents
Advertisement
R2E210-AB34-05
2. INTENDED USE
The device is exclusively designed as a built-in device for conveying
air according to its technical data.
Any other usage above and beyond this does not conform with the
intended purpose and constitutes misuse of the device.
Customer equipment must be capable of withstanding the mechanical
and thermal stresses that can arise from this product. This applies for the
entire service life of the equipment in which this product is installed.
Intended use also includes
Using the device only for conveying exhaust from exhaust blowers
●
for wood-based fuels.
Using the device within the permitted ambient temperature range; see
●
Chapter 3.5 Transport and storage conditions and
Chapter 3.2 Nominal data.
Using the device only in stationary systems.
●
Commissioning the built-in component only after installation in the
●
customer equipment.
Operating the device with all protective devices.
●
Following the operating instructions.
●
Improper use
In particular, operating the device in the following ways is prohibited and
could be hazardous:
Operating the device in an unbalanced state, e.g. due to dirt deposits
●
or ice formation.
Resonant operation, operation with severe vibration. This also
●
includes vibration transmitted to the fan from the customer installation.
Conveying highly corrosive air, e.g. salt spray. Exception: devices
●
designed for salt spray and correspondingly protected.
Operation with external vibrations.
●
Operating the device in an explosive atmosphere.
●
Operation in medical equipment with a life-sustaining or life-support
●
function.
Contact with materials that could damage blower parts, e.g. liquids
●
during cleaning.
Operation with completely or partially disassembled or manipulated
●
protective devices.
Using the device as a safety component or to perform safety-related
●
functions.
In addition, all applications not listed among the intended uses.
●
Item no. 11881-5-9970 · ENU · Change 89188 · Approved 2016-08-26 · Page 3 / 9
ebm-papst Mulfingen GmbH & Co. KG · Bachmühle 2 · D-74673 Mulfingen · Phone +49 (0) 7938 81-0 · Fax +49 (0) 7938 81-110 · info1@de.ebmpapst.com · www.ebmpapst.com
Operating instructions
Advertisement
Table of Contents
