Door Reversal Instructions - Danby DKC054A9SLDB Owner's Manual

OPERATING INSTRUCTIONS

DOOR REVERSAL INSTRUCTIONS

If the appliance is placed on its back or side for any length of time
during this process, it must be allowed to remain upright for 6 hours
before plugging it in to avoid damage to the internal components.
1. Remove the two screws from the back of the worktop. Lift the back
of the worktop and pull it toward the front of the appliance to
remove it. Remove the worktop hinge hole cover from the left side
of the worktop and move it to the hinge hole on the right side of
the worktop.
2. Remove the door spindle cover that covers the hinge on the top
left side of the door. Remove the hole cover from the top right side
of the door. Removing the hole cover may require a fl at blade
screwdriver.
3. Remove the upper hinge from the top right side of the cabinet.
Remove the door from the cabinet.
4. Remove the lower hinge hole cover from the bottom left side of the
door and move it to the bottom right side of the door.
5. Remove the lower hinge from the bottom of the cabinet and
remove the hinge pin from the lower hinge. Flip the lower hinge
over and install the hinge pin on the other side.
6. Remove the adjustable foot from the bottom right side of the
cabinet. Remove the solid foot and screws from the bottom left
side of the cabinet. Install the solid foot on the bottom right side of
the cabinet. Install the lower hinge and the adjustable foot on the
bottom left side of the cabinet.
7. Remove the hinge pin from the upper hinge. Flip the upper hinge
over and install the hinge pin on the other side.
8. Install the upper hinge and door onto the cabinet.
9. Install the door spindle cover to cover the hinge on the top right
side of the door. Install the hole cover in the hole on the top left
side of the door.
10. Install the worktop by laying it on top of the appliance and
pushing it toward the back until it clicks into place and then
reinstall the two screws at the back.
Note: When reinstalling the door, ensure that the top of the door is
level with the top of the cabinet and that the rubber gasket makes a
good seal with the cabinet all the way around.
1
2
3
4
5
6
7
8
9
10
12