DARTY Proline VHP61SS User Instructions page 42

1. Take the dimensions of your cooker in order to have the range hood centred above it. Stick the
installation and drilling template on the wall above your cooker, taking care to comply with the required
minimum distance.
Note: The minimum distance between the supporting surface for the cooking equipment on
the hob and the lowest part of the range hood must be not less than 50cm from electric
cookers and 65cm from gas or mixed cookers. If the instructions for installation for the gas
hob specify a greater distance, this must be adhered to.
Beware: the pattern is designed for 2 different range hood dimensions, therefore you must
make sure to conform to the dimensions of your appliance (60cm).
2. On the wall, mark the position of 3 of the 4 holes showed on the template (2 upper + 1 lower), and drill
the holes by using a drill bit with an 8mm diameter. In the upper holes, insert the supplied wall plugs
(8mm diameter, 40mm depth) and screws (5mm diameter, 45mm depth).
3. Position the hood on the upper screws that you inserted. Remove the grease filter to access the lower
screw, and insert the wall plug and screw.
4. Make sure the appliance is level by using a spirit level, and tighten the screws.
5. The selector [G] located inside the hood, next to the conduit, enables to choose the desired evacuation
mode: suction [position A] or filtering [position F].
4