Philips 5102 Series Service Manual page 19

• By using the CLEAR command in the Factory mode:
• By using the following key sequence on the remote control transmitter: "062599" directly followed by the OK button.
• If the contents of the error buffer have not changed for 50 hours, the error buffer resets automatically.
Note: If you exit SAM by disconnecting the mains from the television set, the error buffer is not reset.
5.3 Panel Code
Press the following key sequence on a standard RC transmitter: "062596" directly followed by MENU and "xxx", where "xxx" is a 3 digit decimal value
of the panel type: see column "Display Code" in below tab. After resetting the Display Code, restart the set immediately.
CTN_ALT BOM#
32PHT5102/71
43PFT5102/71
49PFT5102/71
Panel Type
TPT315B5-1A058.L S24C XM
TPT430H3-HVN01.U S272S
TPT490F2-FHBN0.K S8940R XM
Display Code
214
217
216