Table of Contents
Advertisement
3.2.4 Small Signal Board (SSB)
Refer to 3-4 for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1. Release the clips from the LVDS connector that connect
with the SSB[1].
3-3 Speaker removal
Caution: be careful, as these are very fragile connectors!
2. Unplug all other connectors [2] .
3. Remove all the fixation screws from the SSB [3].
4. The SSB can now be shifted from side connector cover,
then lifted and taken out of the I/O bracket. Refer to 3-4 for details.
3-4 SSB removal
Advertisement
Table of Contents
