Table of Contents
Advertisement
Adjustments and Troubleshooting
Adjustments
Notes
(1)
This set uses an adapter, so connect the adapter and the set correctly before adjustment.
(2)
The adjustment must be performed under the correct sequence.
(3)
The adjustment must be performed in the circumstance of 25±5°C of temperature and 65±10% of relative
humidity if there is no specific designation.
(4)
Maintain 120VAC, 60Hz during all adjustments.
(5)
Allow a 20-minute warm up period before making any adjustments if there is no specific designation.
*
'Heat Run' must be performed with the full white signal or TV noise signal in the internal part of the set.
*
The time for 'Heat Run' can be changed owing to production plan.
Auto RGB Adjustment
Preparation for Adjustment
(1)
Receive the Digital Pattern.
Adjustment
(1)
Select AUTO RGB ADJ by pressing SVC Key of Remote Control for Adjustment.
(2)
Select "A RGB" Item.
(3)
Press the VOL + Key to appear "OK".
RGB LEVEL Adjustment
Using Equipment
(1)
Pattern Generator (408NPS-READER) which 10 STEP is possible.
(2)
A Remote Control for Adjustment
Adjustment
1)
Select RGB LEVEL by pressing SVC Key of Remote Control for Adjustment.
(
(2)
Adjust that until 9th and 10th STEP is undistinguished by using VOL +/- Key in R-LVL item.
(3)
Adjust G-LVL and B-LVL as same way.
(4)
When adjustment is finished, Store it by pressing OK key and escape it by pressing TV/AV Key.
Using method for CA-110
Use it in case of needing adjustment brightness.
Advertisement
Table of Contents
