Advertisement
5. ASSEMBLY
Unpack the product and check contents against the contents diagram (section 4.0) prior to assembly. Should there be any
damaged or missing parts contact your supplier immediately.
5.1.
ATTACHING THE UPPER SUPPORT FRAMES
5.1.1.
Place the work top (fi g 2 - 3 & 3A) top face down onto a protected fl oor surface (use original packaging).
5.1.2.
Align the fi xing holes in the upper support frames (fi g 2 - 4) with the corresponding holes on the work top and secure with M6 x 16
hex socket head screws (fi g 2 - 2).
5.2.
ATTACHING THE BOTTOM SUPPORT FRAMES
5.2.1.
Insert the bottom support frame (fi g 3 - 7) into the square opening of the upper support frame (fi g 2 - 4).
5.2.2.
Determine the desired height required and secure with M8 x 85 hex bolt (fi g 3 - 6), M8 washers (fi g 3 - 5) and M8 hex nut (fi g 3 - 9).
5.2.3.
Repeat for other side.
NOTE: The bottom support frame (fig 3 - 7) can be adjusted in 25mm increments, to give an overall working height of between 680
and 1030mm (fig 4), with a maximum of 10 visible holes (fig 4).
5.3.
ATTACHING THE FRONT STIFFENER
5.3.1.
Position the front stiff ener (fi g 5 - 10) to the front face, top level of the work bench part assembly.
5.3.2.
Secure with M6 x 16 hex socket head screws (fi g 5 - 2).
5.4.
ATTACHING THE BACK STIFFENERS
5.4.1.
Position the back stiff eners (fi g 6 - 1) to the back face, top and bottom levels of the work bench part assembly.
5.4.2.
Secure with M6 x 16 hex socket head screws (fi g 6 - 2).
© Jack Sealey Limited
fi g.3
fi g.5
Original Language Version
fi g.4
APMS22, APMS23 Issue 1 09/08/21
fi g.2
fi g.6
Advertisement
