Kenwood CS-5200 Series Instruction Manual page 39

Figure 10-1
Example : I n F i g u r e
v o l t a g e i s found as shown below, p r o v i d e d t h e VOLTS/DIV c o n t r o l i s s e t to 0. 2
V/div and the 10:1 probe i s used:
Voltage between 2 p o i n t s = 4.4 ( d i v ) x 0 . 2 ( V / d i v ) x 10 = 8. 8 V
• Cursor measurement [CS-5230, 5260, 5270]
(1) Move the waveform to be measured to an e a s y - t o - s e e p o s i t i o n .
(2) P r e s s t h e CURSOR MODE s w i t c h t o s e l e c t t h e v o l t a g e measurement mode.
A R E F a n d A
measurement.
F i g u r e 10-2
Adjust to the center
vertical scale with ,
^ • P O S I T I O N .
Measuring Voltage between Two Points
10, t h e v e r t i c a l d i s t a n c e between t h e two p o i n t s
c u r s o r s i n c o n t a c t
cursor Measured value
Measuring Voltage between Two Points (Cursor measurement)
Points to be measured
Adjust to the horizontal
scale with £ POSITION.
w i t h t h e p o i n t s t o be m e a s u r e d .
REF cursor
i s 4.4 d i v . The
B r i n g t h e
R e a d t h e