Kenwood CS-5200 Series Instruction Manual page 23

® SLOPE +/-
S e l e c t s the p o l a r i t y o f t h e s l o p e of the t r i g g e r s i g n a l .
( + ) , t r i g g e r i n g i s e x e c u t e d a t the l e a d i n g edge of the Input t r i g g e r s i g n a l .
b u t t o n p r e s s e d (-)»
s i g n a l .
® A SWEEP TIME/DIV switch
S w i t c h e s 22 ranges of A sweep time i n 1-2-5 s t e p s between 0. 5 second/div and 50 n s / d i v .
T u r n i n g the H. VARI f u l l y c l o c k w i s e to the CAL p o s i t i o n , the v a l u e i s c a l i b r a t e d .
[21 ranges between 0. 5 second/div and 0.1 / i s / d i v f o r the CS-5230 and CS-5235. ]
© B SWEEP TIME/DIV switch
S w i t c h e s 19 ranges of B sweep time i n 1-2-5 s t e p s between 50 ms/div and 50 n s / d i v .
[18 ranges between 50 ms/div and 0.1
For p r a c t i c a l i t y , we recommend use of a higher-speed range than the A sweep s e t range.
© VARIABLE control (H. VARI)
F i n e - c o n t r o l s the A sweep time c o n t i n u o u s l y i n the range s e l e c t e d w i t h the A-SWEEP TIME/
DIV s w i t c h . T u r n i n g t h e c o n t r o l f u l l y c l o c k w i s e to the CAL p o s i t i o n , the A sweep time
i s c a l i b r a t e d .
® POSITION control
A d j u s t s the h o r i z o n t a l p o s i t i o n of the waveform d i s p l a y e d on the CRT.
S e r v e s as an X - a x i s p o s i t i o n c o n t r o l d u r i n g X-Y o p e r a t i o n .
X 1 0 MAG switch
®
P r e s s t h i s s w i t c h to magnify the d i s p l a y 1 0 x
I NOTE
Do not use x 1 0 MAG
t r i g g e r i n g I s e x e c u t e d a t the t r a i l i n g edge of the I n p u t t r i g g e r
jus/ih
i n X-Y o p e r a t i o n . O t h e r w i s e , the waveform can become n o i s y .
W i t h t h e b u t t o n not p r e s s e d
f o r the CS-5230 and CS-5235. ]
i n the c e n t e r of the CRT.
W i t h the
1
19