Table of Contents
Advertisement
Figure 2: BMOD0010 Mounting Hole Locations
A proper installation should not exert any bending or twisting torque to the module enclosure.
Ensure that the module's mounting points are co-planar within ±1 mm. If the actual mounting
location is out-of-plane, use spacers to bring all four mounting locations within plane to within
±1mm.
BMOD0010 module have been qualified to IEC60068-2-6 for vibration performance. Ensure that
this is adequate for the end-use environment. To ensure meeting specified vibration performance,
all mounting points should be used. If more severe vibration performance is required, consider the
use of isolators to provide damping. Contact Maxwell Application Engineering for assistance in these
cases.
User Manual – BMOD0010 E160 B02 – Doc. No. 3003406.1
© 2022 Maxwell Technologies, Inc.
Page 4
Advertisement
Table of Contents
