Canon S750 Quick Start Manual page 50

Appendix
• Never set the printer on a surface that is unstable or subject to excessive vibration. The printer could tip or fall
and cause injury.
• Never use the printer in a location that is subject to high humidity, dust, high temperatures, or direct
sunlight.
• Set up and use the printer in a location where ambient temperature is within 41°F–95°F (5°C–35°C) and
10%–90% humidity with no condensation.
Never place the printer on a thick carpet or rug. Fibers or dust entering the printer could cause
a fire.
Keep the power outlet for the printer free of all obstacles so you can unplug the power cord at
any time. Such obstacles could prevent you from unplugging the printer when a printer fault
occurs and cause a fire or electric shock. The socket-outlet should be installed near the
equipment and should be easily accessible.
• Always carry the printer with both hands holding both ends of the printer. To avoid dropping the printer and
causing injury, always carry it carefully when moving it to another location.
Power Supply Power Supply Power Supply Power Supply
Never attempt to plug the power cord into a power outlet when your hands are wet. To avoid
electric shock, make sure that your hands are dry.
• Always push the plug completely into the power outlet. A loose or poorly connected plug could cause a fire or
electric shock.
Never cut, modify, stretch, bend, or twist the power cord, and never place heavy objects on the
power cord. A power leak from a damaged power cord could cause a fire or electric shock.
Never plug the printer power cord into a power outlet (power board, double adapter, etc.) that
is shared by other devices or office equipment. To prevent the hazards of fire or electric shock,
avoid overloading power points.
• Never use the printer if the power cord is bundled or knotted. To prevent the hazards of fire or electric shock,
make sure the power cord is straight.
If you detect smoke, unusual odors, or strange noises around the printer, immediately press
the POWER button to turn off the printer and disconnect the power plug. To avoid fire or electric
shock, never use the printer under these conditions. Call the Customer Care Center.
• Always grasp the plug when you unplug the power cord. Pulling on the power cord could damage the cord and
cause a fire or electric shock.
Never use an extension cord. To avoid a fire or electric shock, always plug the power cord
directly into the power outlet.
Never use a power supply voltage other than that supplied in the country where you purchased
the printer. Using incorrect voltage could cause a fire or electric shock. The correct power
supply voltage for this printer is AC 120V, 60 Hz.
Cleaning and Maintaining the Printer Cleaning and Maintaining the Printer
Cleaning and Maintaining the Printer Cleaning and Maintaining the Printer
Use only a slightly damp cloth to clean the printer. Never use flammable solvents such as
alcohol, benzene, or thinner. If a flammable solvent contacts an electrical component inside
the printer, a fire or electric shock could result.
Always unplug the printer power cord before you clean the printer. If you mistakenly turn on the
printer while cleaning it, you could touch moving components inside the printer and suffer injury.
Never attempt to disassemble or modify the printer. The printer contains high voltage
components which could cause a fire or serious electric shock.
46