Naneos PARTECTOR 2 Operation Manual page 9

Data rate
For certification purposes the sensor can store the measurement data with 10Hz to an
internal memory. It is also possible to store the measurement data with 1Hz.
Meas.mode (= measurement mode)
There are two operation modes:
1. "always" (= always on)
o In this mode the sensor does not switch off the pump and the internal high
voltage. This mode is used during the calibration/certification process.
2. "interm." (= intermittent)
o In this mode the sensor switches the pump and the internal high voltage
off after x seconds after measurement. The sensor will switch on the pump
and high voltage automatically when a new measurement is started (e.g.
by pressing the 'meas.'-button
Press the "next" soft button until you are on the field you want to modify, then use the
"up" and "down" soft buttons to change the field's value.
Error messages
If an error occurred, the HEPaC sensor will show 'ERROR' on the home screen. The
PC software will show a detailed error message. Those errors are described in the PC
software section of this document.
Recommendations
If a high concentration (> 3mio) has been measured, it is recommended to turn the sen-
sor off and on again. During startup the sensor performs a selfcleaning procedure."
We recommend connecting the battery charger during heating up to increase the meas-
urement time before having to recharge the battery
PC Software
Introduction
The PC software is used to generate the official measurement reports (in all supported
languages). It also displays the status and real time values of the sensor. The software
communicates via a Bluetooth LE USB dongle with the sensor.
The PC software will be preinstalled on a tablet/laptop and will start automatically after
boot. For installation procedure, please contact us.
The user interface of the software consists of a toolbar and a main window:
9