Naneos PARTECTOR 2 Operation Manual page 8

Status screens
The status screens show the most important device data. You can switch between the
individual status screens by pressing "next".
Ambient
P air pressure [hPa]
RH internal relative humidity [%]
T internal temperature [°C]
Alt calculated height above sea level [m]
Note: Altitude is calculated for average pressure. It may be off by several 100 me-
ters if ambient air pressure is very high or low due to a high- or low-pressure area
passing through.
corr current ambient pressure and temperature compensation [%]
High voltage
HV charger corona voltage [V]
Idiff charger diffusion current [nA]
DV deposition voltage [V]
Electrometers
EM1 signal of electrometer 1 [mV]
EM2 signal of electrometer 2 [mV]
A1 electrometer 1 amplitude [mV]
A2 electrometer 2 amplitude [mV]
Miscellany
Batt battery voltage [V]
Error displays the current error status (0 = no error)
Flow approximate flow through device [lpm]
ThermoController
Ts_pt sensor set temperature
Ts_pr evaporation tube set temperature
T_pt sensor measured temperature
T_Pr evaporation tube measured temperature
PWM_pt heating power sensor
PWM_pr heating power, evaporation tube
Charger
Vbat battery voltage
Vin Input voltage
Ichrg charging current
Fault error
Config screens
Time and Date: the internal clock of the HEPaC has an accuracy of about 1s per day. It
does not change to daylight saving time and back automatically. Therefore, you may
need to set the clock from time to time.
8