Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for swepac T82
Summary of Contents for swepac T82
- Page 1 USER MANUAL IN ORIGINAL Dok: 101540-GB 2051...
-
Page 2: Table Of Contents
Swepac T82 is suitable for compacting soil in several applications as, trenches, close to curbs, around poles and in general restricted spaces. The Tampers is also suitable to be used when the soil is mixed with clay, because of the high stroke movement. The compact design ensures good accessibility in tight... -
Page 3: Safety Instructions
SAFETY INSTRUCTIONS STANDARDS Noise Measurement in accordance with the standard EN • Before using the machine, the operator must be in- 500-4 Rev. 1:1998, Annex C: formed of the manufacturer’s safety instructions and Measurement uncertainty ± 0.5 dB (A) in 95% of the instructions for use. -
Page 4: Signs
SIGNS Warning Signs NOTE! Use only the machine´s lifting eye to lift the machine. Machine Signs Before use, carefully read the manual and its safety instructions so that you can handle the machine safely. Ensure that the manual is always accessible. Engine and silencer: to avoid burns or discomfort, do not touch hot engine parts when the engine is on or 1. -
Page 5: Technical Data
AFS 2005:15 from the Swedish Work Environment Authority, effective July 1st 2005. Measurement uncertainty ± 0.3 m/s2 in 95% of the measurements. Hand/armvibrations, m/s FUEL and OIL RECOMMENDATIONS Fuel T82..............Diesel Engine oil ............SAE 15W-40 Ramming cylinder oil........SAE 15W-40... -
Page 6: Description
DESCRIPTION Fuel filter 1. Throttle control 2. Guiding handle 3. Cover 4. Fuel filter 5. Air filter 6. Engine 7. Crankase with below 8. Spring cylinder 9. Transport handle 10. Tamper plate 11. Roller 12. Lifting eye 13. External air filter... -
Page 7: Engine
Engine Starting the engine Start by pulling the starting handle. Pull it first until the mechanism engages. Then pull it hard and fast. Press the lever down and hold it down until the flywheel has reached its maximum RPM. Then let it go. STOPPING Switch the engine to the idle position idle, let it run for a few minutes, then switch it to stop. -
Page 8: Maintenance
MAINTENANCE Periodically Maintenance Comments Check for lose screws, nuts etc Clean engine cooling fins See engine manual Every 5 hours of operation Maintenance Comments Check air cleaner elements See engine manual. Every 25 hours of operation Maintenance Comments Check shoe hardware Every 50 hours of operation Maintenance Comments... - Page 9 MAINTENANCE - EVERY 10 HOURS OF OPERATION Check oil level in the tamper leg through the sight glass (1) The level should be at the middle of the sight glass. Check and, where necessary, tighten screws and nuts. Take special care with bolted joints on the rammer foot. Keep machine clean.
- Page 10 INSTRUCTIONS FOR LIFTING Keep well clear of the hoisted machine. Use only the frame lifting hook (1) for lifting the machine. All lifting devices must be dimensioned in order to full fil all regulations. Before lifting check that ramming shoe is correctly attached and not damaged.
- Page 11 DIMENSIONS Contact Contact surface surface A mm B mm C mm 1150 D mm E mm...
-
Page 12: Troubleshooting
TROUBLESHOOTING TROUBLE POSSIBLE CAUSE REMEDY Engine stalls or does not start No fuel in tank Fill with gasoline, check the fuel filter Fuel valve closed Open the fuel valve Engine does not accelerate, Air filter is dirty Clean/replace the air filter ishard to start or runs Motor oil low Fill with motor oil... - Page 13 NOTES...
- Page 14 NOTES...
-
Page 15: Notes
NOTES... - Page 17 SWEPAC AB Address Bergvägen 7, 341 32 Ljungby, tel 0372-156 00, fax 0372-837 41, Email mail@swepac.se, Internet www.swepac.com...
Need help?
Do you have a question about the T82 and is the answer not in the manual?
Questions and answers