Hover-1 FLEX Operation Manual
  1. Manuals
  2. Brands
  3. Hover-1 Manuals
  4. Scooter
  5. FLEX
  6. Operation manual

Hover-1 FLEX Operation Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
E L E C T R I C S C O O T E R
OP E RAT I ON M A N U A L
EU - H 1- FL X

Advertisement

Table of Contents
loading

Related Manuals for Hover-1 FLEX

Summary of Contents for Hover-1 FLEX

  • Page 1 E L E C T R I C S C O O T E R OP E RAT I ON M A N U A L EU - H 1- FL X...
  • Page 2 HELMETS SAVE LIVES! Always wear a properly tted helmet that complies with CPSC or CE safety standards when you ride your scooter. Correct Fitting: Make sure your helmet covers your forehead. Incorrect Fitting: Forehead is exposed and vulnerable to serious injury.
  • Page 3 PLEASE READ THE USER MANUAL THOROUGHLY. Failure to follow the basic instructions and safety precautions listed in the user manual can lead to damage to your Flex, other property damage, serious bodily injury, and even death. Thank you for purchasing the Hover-1 Flex Electric Scooter. Please read all instructions carefully before using and retain this manual for future use and reference.
  • Page 4 Flex. • Do not use the Flex if it has been dropped or damaged in any way. • Repairs to electrical equipment should only be performed by the manufacturer.
  • Page 5 • Do not operate or allow others to operate the Flex until the user understands all instructions, warnings and safety features described in this manual. • Check with your doctor if you have a medical condition that could affect your ability to use the Flex.
  • Page 6 Flex scooter. Operating the Flex without following the contents of this manual may lead to damage to your Flex or bodily injury. This manual is designed to give you the information you need for the safe operation and maintenance of your Flex.

  • Page 7: Specifications

    The Flex uses digital electronic gyroscopes and acceleration sensors to control balance and motion, depending on the user's center of gravity. The Flex also uses a control system to drive the motors that are located within the wheels. The Flex has a built-in inertia dynamic stabilization system that can help assist with balance when moving forward and backwards, but not while turning.

  • Page 8: Controls And Display

    PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY TURNING YOUR DEVICE ON/OFF Power On: Take your Flex out of the box and place it flat on the floor. Press the power button (located on the rear of your Flex) once. Check the LED indicator (located in the center of your Flex). The battery indicator light should be lit, indicating the Flex is powered on.

  • Page 9: Before Riding

    BEFORE RIDING It is important that you fully understand all elements of your Flex. If these elements are not used correctly, you will not have full control of your Flex. Before you ride, learn the functions of the various mechanisms on your scooter.

  • Page 10: Safety Precautions

    Hover-1 is not liable for tickets or violations given to riders who do not follow local laws and regulations. • For your safety, always wear a helmet that meets CPSC or CE safety standards.
  • Page 11 Flex to fail, resulting in injury or death. • Do not use the Flex in a manner that would put people or property in danger. • If riding near others, keep a safe distance to avoid collision.
  • Page 12 • Operate your Flex with extreme caution when indoors, especially around people, property, and narrow spaces. • Do not operate the Flex while talking, texting, or looking at your phone. • Do not ride your Flex where it is not permitted.
  • Page 13 • Do not attempt any stunts or tricks with your Flex. • Do not ride the Flex in dark or poorly lit areas. • Do not ride the Flex off road, near or over potholes, cracks or uneven pavement or surfaces.
  • Page 14 Stand directly behind your Flex and place one foot on the corresponding foot mat (as described in the diagram below). Keep your weight on the foot which is still on the ground, otherwise the Flex may begin to move or vibrate, making it difficult to step on evenly with your other foot.
  • Page 15 When you first begin using your Flex, the fastest way to move in your desired direction is to focus in that direction. You will notice that just...
  • Page 16 Flex. Dismounting your Flex can be one of the easiest steps, yet when done incorrectly, may cause you to fall. To properly dismount, from a stopped position, lift one leg up and set your foot back down on the ground (STEPPING BACK).

  • Page 17: Balance & Calibration

    If your Flex is unbalanced, vibrating, or not turning properly, you can follow the below steps to calibrate it. • First, place the Flex on a flat, horizontal surface such as the floor or a table.  The foot mats should be even with each other and not tilted forward or backward.  Make sure the charger is not plugged...

  • Page 18: Safety Alerts

    • Unsafe riding surfaces (uneven, too steep, unsafe, etc.) • When you step on the Flex, if the platform is tilted more than 10 degrees forward or backward. • Battery voltage is too low.

  • Page 19: Charging Your Flex

    • While sustaining a high discharge current during use (such as driving up a steep slope for a long period of time), the Flex engine will power off and stop after 15 seconds. WARNING When the Flex turns off during a Safety Alert, all operation systems will halt.

  • Page 20: Battery Care / Maintenance

    • Do not connect or attach the Flex or the battery to a power supply plug or directly to a car’s cigarette lighter. • Do not place the Flex or batteries near a fire, or into direct sunlight. Heating the Flex and/or the battery can cause additional heating, breaking, or ignition of the battery inside the Flex.
  • Page 21 Use of any other charger or cable voids the manufacturer warranty. • Do not use your Flex if the battery begins to emit odor, overheats, or begins to leak. • Do not touch any leaking materials or breathe fumes emitted.

  • Page 22: Care And Maintenance

    • Do not dispose of the Flex in fire as it may explode or combust. • Do not expose the Flex to contact with sharp objects as this will cause scratches and damage.

  • Page 23: Warranty

    WARRANTY For warranty information, Please visit us at: www.hover-1.eu Affix Serial Number Label Here: TROUBLESHOOTING For UK Customer Service, please contact +44 (0) 1355 241222 / escooters@letmerepair.co.uk For other countries, please scan QR code below for more information. WEEE DIRECTIVE...
  • Page 24 CHARGER LABEL use with: drive (eu-h -flex) SWITCHING POWER SUPPLY model: XXXXX input: 100-240 vac, 50/60Hz, 0.8A max ip20 output: 26V 0.4A ta=40 risk of electrical shock. please do not open. for indoor use only. dry location use only. do not remove this tag.
  • Page 25 FOR YOUR SAFETY, PLEASE READ THE ENTIRE USER MANUAL BEFORE OPERATING THE HOVER-1 SCOOTER. • Always wear proper protective equipment, such as helmets. Helmets should fit properly with the chin strap in place, so that it provides protection for your entire head.
  • Page 26 @RideHover1 @RideHover1 @RideHover1 www.Hover-1.eu...

This manual is also suitable for:

Eu-h1-flx

Table of Contents