Table of Contents
Advertisement
On the 2011 Sorento (XM), and other Kia models that utilize the new electronically controlled
6-speed automatic transaxle, the ATF level can be checked by following the procedure below.
ATF Level inspection:
NOTE:
Use only Kia approved ATF meeting Type-4 specification. Using the wrong ATF type may result in
degradation of shift quality, or may cause durability issues.
1. If the ATF has been drained, add approximately 5-qts of Kia Type-4 ATF.
2. After attaching GDS, select vehicle; then A/T menu; then Current Data, and then Oil
Temperature Sensor.
3. Drive vehicle long enough to warm up ATF to approximately 122-140°F (50-60°C).
4. Depress the brake pedal and move the shift lever into "R", "N" and "Drive" and then back,
pausing 2 to 3 seconds in each gear range.
Repeat this procedure two times.
5. Move shift lever to "Park", leave the engine running, and then lift up vehicle on hoist.
6. Remove the splash shield under the automatic transaxle.
7. Remove the oil level plug. ATF level is correct if the ATF flows out in a thin steady stream. If no
ATF flows out, go to step 8.
8. If ATF flow does not occur, add Kia Type-4 ATF via the oil level hole until ATF flows out in a thin
steady stream.
Advertisement
Table of Contents
