Advertisement
1
2
3
CONTROLS
1. Power and Factory
Reset—Hold 1 second for power ON or OFF. Press and hold 5 seconds
to restore Factory Settings. Tap to exit MENU settings.
2. VOLUME Plus/Minus
buttons—Use to increase / decrease detector volume.
3. SENSITIVITY Plus/Minus
buttons—Use to increase / decrease Sensitivity setting. These
buttons are also used while adjusting MENU settings.
4. MENU/Iron
Check— Repeatedly press to scroll through Menu items, then use the Plus
(+) or Minus (-) buttons above MENU to change setting. Press and hold button to use Iron
Check function.
5. THRESHOLD
Plus/Minus—Use to adjust the background audio hum that is added to
target response.
6. Ground
Balance—Hold down while bouncing coil above ground until ground response
disappears or becomes as small as possible.
FACTORY DEFAULT SETTINGS
Sensitivity:
6
Volume:
24
Threshold:
15
Mode:
Fine
Frequency:
50
Tone:
50
4
5
6
Audio:
01(VCO)
Ground Balance:
49/49
Wireless:
Off
Backlight:
Off
Speed:
Medium
Ground Track:
Off
15
1
2
3
4
5
6
LCD/DISPLAY ELEMENTS
1. Signal Strength
Indicator—indicates both signal strength and polarity.
2. Iron
Check—Indicates that Axiom's Iron Check feature is in use.
3.
Mode—Select from Fine, Normal, Large or Salt.
4. Frequency
Scan—To overcome EMI, highlight FREQ SCAN on Menu, and press Plus (+) Menu
button to begin the scan. Takes approximately 45 seconds.
5.
Tone—Scroll through 00 to 99 to select your preferred audio tone.
6. Audio
Type—Select 00 for PWM audio or 01 for VCO audio..
7.
Sensitivity—Indicates current Sensitivity setting.
8. Battery
Level—Shows status of battery life (25% per segment).
9.
Speed—Select Slow, Medium or Fast detection speed.
10. Ground
Track—Select Off, Slow, Medium or Fast continuous ground tracking speeds.
11.
Backlight—Indicates LCD Backlight is on.
12. Wireless
headphones—Press Plus (+) Menu button to pair to headphones or Minus (-) to
unpair. Icon flashes while attempting to pair; is solid when unit is paired with headphones.
13. Gnd Balance
Arrows—Indicates trending direction of ground balance when Gnd Track is on.
14. Gnd Balance
Indicator—Displays while performing ground balance.
15. Ground Balance
Values—are shown by the upper and lower 2-digit numbers.
14
13
12
11
7
8
9
10
Advertisement
