Fcc Rf Exposure Information (Sar) - Zte Blade X8 Quick Start Manual

FCC RF Exposure Information (SAR)

This tablet is designed and manufactured no t to exceed the emission
limits for exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the United States.
During SAR testing, this device was set to transmit at its highest certified
power level in all tested frequency bands, and placed in positions that
simulate RF exposure near the body with the separation of 10 mm.
Although the SAR is determined at the highest certified power level, the
actual SAR level of the device while operating can be well below the
maximum value. This is because the tablet is designed to operate at
multiple power levels so as to use only the power required to reach the
network. In general, the closer you are to a wireless base station antenna,
the lower the power output.
The exposure standard for wireless devices employing a unit of
measurement is known as the Specific Absorption Rate, or SAR. The
SAR limit set by the FCC is 1.6 W/kg.
This device is complied with SAR for general population/uncontrolled
exposure limits in ANSI/IEEE C95.1-1992 and had been tested in
accordance with the measurement methods and procedures specified in
IEEE1528.
The FCC has granted an Equipment Authorization for this model tablet
with all reported SAR levels evaluated as in compliance with the FCC RF
exposure guidelines. SAR information on this model tablet is on file with
the FCC and can be found under the Display Grant section of
www.fcc.gov/oet/ea/fccid after searching on FCC ID: SRQ-ZTET0801.
The FCC ID also can be found on the device when you open
Settings >About tablet > FCC ID : SRQ-ZTET0801.For this device, the
highest reported SAR value for usage near the body is 0.93 W/kg.
While there may be differences between the SAR levels of various tablet
and at various positions, they all meet the government requirements.
SAR compliance for body-worn operation is based on a separation