Needit Park Life Instructions For Use

Park Life
Developed by Needit Denmark
Designed by John Sebastian
Instructions for use
2
1
www.park-life.dk
Let's get started with your
Park Life
A: How to activate your :
Park Life
With the back of the parking disk facing you, place tree fingers on top of the large cen-
tered round button and turn it clockwise until the two small dots meet and the
logo is parallel to the inner display. Within 15 seconds "hours" flashes in the dis-
Life
play and the unit is ready to be set. (To deactivate; turn the large button counter clock-
wise until the display shows no numbers. Wait min. 2 minutes before reactivation).
B: How to set the digital clock:
(The parking disc clock sets automatically even when the clocks go back or
Park Life
forward (daylight saving time). However, if necessary, this function can be deactivated
manually (see C: below).
1. If A: How to activate your is followed, please skip step 1., otherwise
Park Life
continue as follows: To activate the setting function, press and hold down the
lower part of the large button (aprox. 10 sec) until "hours" starts to flash.
❶
2. When "hours" flashes, press repeatedly on the upper part of the button
the clock is set at the correct hour.
3. Press once until "minutes" starts to flash. Set minutes by pressing
❶
4. Set year, month and date as described above (in this order).
When the above settings is completed, none of the digits in the display should flash.
NB: Note, however, that the two dots (:) between the hours and minutes flash all the
time. If one of the digits flashes, press repeatedly until no digits are flashing. If you
❶
discover that you have set incorrectly, you can always start again. Press and
Park Life
hold down (aprox. 10 sec) until the "hours" digit flashes.
❶
We recommend that you check the parking disc settings regularly, especially at day-
light saving time.
C: Activating/deactivating daylight saving time:
By default, the digital clock is set to change automatically to and from daylight saving
time. If, however, you are in a country, which does not use daylight saving time, you
can deactivate this function as follows:
2
1. To activate the setting function, press and until "hours" and "minutes"
❶ ❷
show "oN:Su" in the display.
2. Carefully release .
❶
1
3. Press and hold down until you read "oF:Su" in the display.
❷
4. The display reverts automatically to normal function.
Your is now ready for fitting on the inside of your car windscreen.
Park Life
Don't forget: you are permitted to have only one parking disc in the vehicle and that
the driver is always responsible for setting the clock correctly.
Needit ApS and Needit Denmark ApS do not refund parking fines.
How to fit
Park Life
Find a suitable spot inside the car at the lower, right-hand corner of the windscreen
(this is a legal requirement) where all four adhesive pads are in contact with the glass.
Make sure that you can access all the buttons on the back of the parking disc.
1. Clean the area on the inside of the windscreen where you will fix your parking
disc, with a damp cloth and a little household detergent. Dry the windscreen and
then use the enclosed cleaning cloth to thoroughly degrease the area. (Use the
enclosed cleaning cloth – no other cleaning agents).
2. Make sure that the windscreen is at least +15°C. The adhesive pads are not as
effective at lower temperatures. The glass can be heated using the car heater or
(carefully) with a hair dryer.
3. Remove the protective foil from the four adhesive pads and press the parking
Park
disc hard against the glass for about 30 seconds. Do not press on the middle of
the back of the disc. Check from the outside that all four adhesive pads have
adhered to the glass.
4. You have now fitted your parking disc and are ready to drive.
Park Life
NOTE!
parking disc should not be left unattached in the car. Your parking disc will
Park Life
not function correctly unless it is securely attached to the windscreen.
How does work?
Park Life
When you park your car, sets automatically to the next quarter of an hour
Park Life
after your time of arrival (e.g. if you arrive at 10:07,
until
❷
The driver of the vehicle is responsible for ensuring that the disc is set correctly.
Needit ApS and Needit Denmark do not refund parking fines and Needit cannot accept
.
❷
responsibility for defective fitting.
How to set arrival time manually
Your can also be set manually. This function is a legal requirement in
Park Life
Denmark. Executive Order no. 150 of 24/02/2016 (Article 3(3)) states: "If, while the
vehicle is parked, a period begins in which unlimited parking is permitted, the parking
disc must be set to display the time for the beginning of the parking period or (no later
than the end of this period) to display the time from which a new limited parking pe-
1
riod will begin." If you need to set your parking disc manually, press
Park Life
the clock will run on at 15-minute intervals. NB: This function is only accessible when
parking disc is in parking mode.
Park Life
Batteries
has a product lifetime battery, which means you will not need to change
Park Life
the battery. Under normal circumstances, the battery in any
least 10 years.
Service and guarantee
If you have questions about your new , you will find many answers on our
Park Life
website at www.needit.dk. If you have questions, you are also welcome to send an
e-mail to kundeservice@needit.dk. Needit ApS and Needit Denmark ApS provide a
product guarantee in accordance with the Danish Sale of Goods Act. If, during the guar-
antee period, you find an error or defect in your
Park Life
it to the retailer, from whom you bought the disc. The disc will be repaired or replaced.
If you have a complaint, please bring a copy of your receipt (as proof of purchase).
2
Approvals and certificates
is approved by the Danish Transport Authority in accordance with Executive
Park Life
Order no. 150 of 24/02/2016 on parking discs and approval code FS29 is imprinted on
the front.
CE labelling
By means of the CE label on the parking disc, Needit ApS declares that our product
meets the general safety requirements contained in the CE labelling directives. By
means of the CE label, the manufacturer guarantees that the product is manufactured
in accordance with joint European safety, health and environmental requirements.
Needit ApS declares that this parking disc meets (CE) EN 55022 (Radio Disturbance
Characteristics) and (CE) EN 55024 (Standards for Commercial Electronic Products)
requirements.
WEEE
Electrical and electronic components (EEE) and materials can be harmful to the health
sets itself to 10:15). and environment, and must be correctly disposed of.
Park Life
is not to be disposed of in the general trash, but has to be disposed of indi-
Park Life
vidually. The battery can be returned at any retailer selling batteries, and the actual
can be disposed of at your local recycling station or at the retailer.
Park Life
3
and Specifications and rights
❷
Size (cm): 10 x 10 x 1.5
Battery specification: Lithium cell that does not require replacement within the prod-
uct lifespan
Battery lifetime: Min. 10 years
Clock precision (avg.): ± 2 min./2 years
will work for at
Park Life Response time – parking: About 20 seconds
Response time – exit parking mode: About 20 seconds
patent applied for.
Park Life
All rights to the
Park Life
Needit ApS • Hammerholmen 18 • DK-2650 Hvidovre
parking disc, you can return Telephone: +45 70 221 535
E-mail: kundeservice@needit.dk
Web: www.needit.dk
Needit reserve the right to make changes to the content of these instructions without
prior warning.
NOTE:
The driver of the vehicle is responsible for ensuring that the disc is set correctly.
Needit ApS and Needit Denmark do not refund parking fines and Needit cannot accept
responsibility for defective fitting nor setting.
4
5
product are the property of:
6