Table of Contents
Advertisement
ASSEMBLY AND OPERATING
WARNING:
To prevent serious injury, gaskets must be used. Only use the gaskets provided with this
grinding wheel. Gaskets help prevent grinding wheel damage, wheel slippage and wheel
failure.
6. Thread the Outer Flange onto the Spindle. Wrench tighten only enough so that the
wheel is securely held on the spindle.
WARNING: To prevent serious injury, do not over tighten flange. Over tightening can
damage the wheel, causing wheel failure.
INSTALLING A THREADED ACCESSORY
WARNING: TO PREVENT INJURY: Wear heavy-duty work gloves when handling wire
wheels and brushes. These accessories are sharp and can cause injury.
1.
The accessory MUST be:
·
Rated to at least 11,000 RPM.
·
No larger than 4
·
Fitted with a threaded opening of
·
Undamaged.
·
A sanding disc and backing pad, a sanding flap disc, a wire wheel or a wire cup
brush (accessories not included).
2.
Press in and hold the Spindle Lock (21) to prevent the Spindle (6) from turning.
3.
Remove the Outer Flange (1) and the Inner Flange (2) and keep in a safe place.
4.
Thread disc accessory firmly onto the Spindle. Use wrench to tighten onto the Spindle.
WORK PIECE AND WORK AREA SET UP
1.
To prevent distraction and injury designate a work area that is clean and well-lit. The
work area must not allow children or pets access.
2.
Route the power cord along a safe route to reach the work area without creating a
tripping hazard or exposing the power cord to possible damage.
3.
The power cord must reach the work area with enough extra length to allow free
movement while working.
4.
Secure loose work pieces using a vise or clamps (not included) to prevent
movement while working.
5.
There must not be hazardous objects, such as utility lines or foreign objects, nearby
that will present a hazard while working.
6.
You must use personal safety equipment including, but not limited to, ANSI-
approved eye and hearing protection, as well as heavy-duty work gloves.
7.
Before beginning work, provide for sparks and debris that will fly off the work surface.
13
4
/
" in diameter.
1
2
5
/
" Angle Grinder - Owner's Manual
1
2
(continued)
/
–11 UNC.
8
Advertisement
Table of Contents
