Advertisement
CHARGE VEHICLE FOR PLAYSET (speed mode)
1.
Move charger switch to position 1 and place vehicle
action lever in "normal" mode (back position).
• Line up holes on bottom of kart with pins as shown.
Contact points on bottom of kart must line up with
contact points on charger.
• Push down on top of kart to engage.
CONTACT
POINTS
CHARGE VEHICLE FOR FREE PLAY (stunt mode)
Move charger switch to position 2 and place vehicle action
lever in "feature" mode (forward position) before charging.
Charge for 5 to 10 seconds. Place kart on a hard, smooth
surface and release with a forward motion (Kart will run for
approximately 15 seconds each time it is fully charged) .
INSTALL BATTERIES
Using screwdriver ( not included ),
remove center screw to open battery
door as shown. Insert 3 "AA" batteries
( not included ).
Be sure to insert batteries as
indicated. Replace and refasten
battery door. If kart does not fully
charge in 20 seconds, replace
batteries.
For best performance, use alkaline batteries.
HOLES
PINS
CONTACT
POINTS
CHARGER
SWITCH
2.
Hold charger with one hand and then
press down on top of kart as shown, with
the other. Rear wheels will start to spin.
DO NOT hold wheels; allow them to spin
freely. Press down for 20 seconds to fully
charge kart. (Do not charge kart for more
than 25 seconds, as overcharging may
reduce the life of your kart.)
Release kart with a forward motion on
playset.
LEVER
BOTTOM VIEW
Advertisement
