Advertisement
possible within no more than 10 minutes
after battery insertion!
6
REGISTRATION PROCEDURE
1) For operating with Security Hub set the fre-
quency Lit.1 and operating Mode 2.
2) Start registration on the Security Hub mobile
app or web app. Registration starts for 45-60 sec.
3) Insert battery into the detector:
Make sure that the registration is successful
Security Hub mobile app. If registration fails,
repeat the procedure.
7
INSTALLATION PLACE
1) Recommended installation height is 2.4-3.6 m.
2) The detector should be installed on the ceiling
(or other surface) strictly horizontally.
To eliminate false alarms
It
is
recommended
to
air-vents, switch off fans, air-conditioners and
other sources of intense air flows in premises
.
during protection period
8
INSTALLATION PROCEDURE
1) Remove cover by
2) Remove PCB
turning it counter
clockwise
3) Mount the base on a ceiling
Attention!
detector base on a hard flat surface.
4) Install PCB.
5) Install the cover by turning it clockwise
6) Perform TEST pass (see section 9).
close
all
doors,
9 TEST PASS
Install jumper on PIR plug.
1)
2) Power up the detector. LED starts flashing
once per 2 sec. during 60 sec.
3) Assemble the detector.
4)
To detect the
sensitive zones carry out
TEST-pass in the
secured zone with the
speed of 0,3 and 3 m/s
Stop upon detection
(LED lights up for 1
sec.), mark position, then
make 2 steps back and continue moving
forward.
For safe extrusion of the caps fix the
.
Repeat TEST-pass
inversely.
10 WARRANTY
The operation warranty period is 5 years from
the date of operation start-up but no longer than
5 years 6 months from the date of manufactur-
ing
subject to the requirements of Operating
Manual.
Advertisement
