Canon CanoScan N1240U Quick Start Manual page 6

Windows 98 / 2000 Professional
The screen shots in this section are from Windows 98.
1.
Turn the computer on.
2.
When [Add New Hardware Wizard] appears,
click [Next].
3.
Confirm that "Search for the best driver for your
device. (Recommended)" is selected and click
[Next].
4.
Place the CanoScan Setup Utility CD-ROM in the
drive.
5.
Confirm that "CD-ROM drive" is selected, wait
for 10 seconds, and then click [Next].
If "Driver Not Found" appears, click [Back] and repeat
this step.
6.
When "CanoScan N670U/N676U" or "CanoScan
N1240U" appears, click [Next].
The driver will begin to install.
Windows 98 Users
If prompted to insert the Windows 98 CD-ROM, follow
the instructions below.
a. Click [OK].
b. Click [Browse].
c. Select the CD-ROM drive and click [OK].
d. Click [OK].
Windows 2000 Professional Users
If the message box "The software you are about to
install does not contain a Microsoft digital signature."
appears, continue installation by clicking [Yes].
7.
Click [Finish].
4
N670U/N676U/N1240U Quick Start Guide
Install the Software