Restoration Hardware 26100048 Quick Start Manual

Large river rock fire bowl

Advertisement

Quick Links

Style # 26100048
Large River Rock Fire Bowl

WARNINGS

!
!
1. Unit is designed to be used with approved Restoration Hardware gel fuel only. Do not use with any
other gel fuel or any other flammable material.
2. Do not use unit without main plate fastened in place according to assembly instructions.
3. Unit is not designed or intended for burning wood or any materials other than approved Restoration
Hardware gel fuel.
4. Read entire label and instructions before using gel fuel.
5. Exercise the same precautions as you would with any other open fire. Never leave a burning fire
unattended, especially around children or pets.
6. When operating unit be sure that the material surrounding the unit is non-combustible and it
is clear and free of all flammable materials.
7. Never touch unit during or after burning gel fuel. Base and glass may be extremely HOT.
Allow base, metal and troughs to cool for 30 minutes before touching.
8. Keep away from children and pets. Unit is not to be operated by children.
9. Do not attempt to refill or replace trough while unit is burning.
10. Make sure unit and gel fuel are burned on a flat and level surface.
11. Do not alter unit in any matter.
12. Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this product.
13. Do not burn trash, leaves, paper or any material other than approved Restoration Hardware gel fuel
in this bowl.
14. Do not cook over the fire produced by this unit.
15. Do not wear flammable or loose clothing when using the unit.
16. Do not attempt to move or store the unit until 30 minutes after gel fuel has been extinguished.
17. Do not lean over unit when lighting or when in use.
18. Do not burn gel fuel outside designated burn area.
19. In case of an emergency use a CO2 extinguisher to extinguish the fire.
20. Death, serious injury or damage to property may occur if the above is not followed exactly.
NOTICE: Buyer assumes all responsibility for safety and use
that is not in accordance with instructions and warnings.
Using your Fire Bowl
- Fire Bowl is intended for outdoor use only.
- Use extreme caution while burning. Some surfaces become extremely hot during use.
- Follow all instructions included with gel fuel before use.
- Before using Fire Bowl, be sure you have read and understand the step-by-step instructions.
- After several burns, soot may develop on the bottom of the damper. Clean with warm soapy water
or any household glass cleaner.
- Clean stainless steel troughs by scraping them with the included scraper tool.
- During the initial burn you may experience a slight odor. Odor is temporary and will be absent on
following burns.
!
2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 26100048 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Restoration Hardware 26100048

  • Page 1 WARNINGS 1. Unit is designed to be used with approved Restoration Hardware gel fuel only. Do not use with any other gel fuel or any other flammable material. 2. Do not use unit without main plate fastened in place according to assembly instructions.
  • Page 2 Step One Parts List - Install Main Plate (2) onto the Base (1) using four screws (8) with Number Description Part Number Quantity washers (9). Fire Bowl Main Plate Damper Trough Scraper River Rocks 1 Bag Cover Screws 10-10 Washers 10-11...
  • Page 3 Step Two Step Three - Install both Troughs (4) into the open areas of the Main Plate. - Spread the river rock evenly on the main plate and within the top of the damper. Any river rocks that fall into the troughs must - Place the Damper (3) in the center of the Main Plate with the bar be removed prior to operating the Fire Bowl.
  • Page 4 Step Four Step Five - With the trough in place; ll with Restoration Hardware - The damper should be centered so that there is an even amount of approved gel fuel. space open on each trough. - Fill the cup to a maximum of 3/4” from the lip of the cup.
  • Page 5 Step Six Step Seven - To extinguish ames use the scraper tool. Place the hole at the end The Fire Bowl and all of its components should be cool to the touch opposite the handle over the pin in the center of the Damper. before attempting to cover the Fire Bowl.
  • Page 6 Care and Cleaning Burn trough should be cleaned every two burns. This can be cleaned using the scraper tool included. - Allow trough to cool completely before attempting to clean. - Place the straight edge of the scraper into the can and pull along the edge.

Table of Contents