RAB EZPAN HE 1X4 Instructions

INSTRUCTIONS
EZPAN® HE INSTALLATION
RAB Lighting is committed to creating high-quality, aff ordable, well-designed and energy-effi cient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We'd love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: marketing@rablighting.com
EZPAN HE 1X4
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is
required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining xture. No user serviceable parts inside.
CAUTION: For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened
rmly. Apply weatherproof silicone sealant around the edge of the ceiling mounting box and/or junction box. This is
especially important with an uneven ceiling surface. Silicone all plugs and unused conduit entries.
RECESSED CEILING MOUNTING
The fi xture is suitable only for INDOOR RECESSED CEILING
application. Above ceiling access required.
To mount in an insulated or non-insulated ceiling - 9/16" or 15/16"
exposed Flat Tee Grid Ceiling follow the steps below.
1. Firmly bend the pre-installed Grid Clips (up and out as shown)
Fig. 1.
2. Rotate and slide the Fixture as required to fi t through the
Tee-Grid Bar and place it as indicated by the directional arrow
as shown in Fig. 2. Secure the Fixture to the Tee-Grid Bar.
3. Support wires are required by Installation Codes. Support the
Fixture to the building structure by Support Wires (supplied by
others) through the Grid Clip Hole as shown in Fig. 3.
4. Make sure that the orientation of the Splice Box and Access
Plate faces an accessible tile to make electrical splices.
5. Loosen Access Plate Screw and remove the Access Plate.
Knock out appropriate Conduit Knockouts on the Access Plate
to route input conduit. Use appropriate conduit connectors as
required by code as shown in Fig. 4.
6. Connect wires as shown in wiring diagram. Push all wires
back into the Splice Box. Use appropriate UL approved wire
connectors as required by code to complete wiring. Be careful
not to pinch wires. WARNING: To prevent wiring damage or
abrasion, do not expose wiring to edges of sheet metal or other
sharp objects.
7. Replace Access Plate and tighten Access Plate Screw.
EZPAN HE 2X2
Fig: 1
Grid Clip
Fig: 2
Fig: 3
Fig: 4
EZPAN HE 2X4
Fixture
Firmly bend Grid
Clips up and out
Access
Splice Box
Plate Screw
Support Wire
(supplied by others)
Grid
Power
Clip
Feed
Access Plate
Conduit
Knockouts
Fixture
Tee-Grid
Bar
Grid Clip
Hole
1.6"