Advertisement
Available languages
Available languages
•
Ventilation parts that you can obtain
from authorized service or authorized
dealers are given in the table on pages
12-13. The X1 column given in the table
includes "Naber" company codes, the
X2 column includes the codes of our
authorized service.
Electrical connection of the appliance
(Figure E)
•
Connect the appliance to a grounded
outlet/line protected by a fuse that
is compatible with the values in the
"Technical specifications" table. Have
the grounding installation made by
a qualified electrician while using the
product with or without a transformer.
Our company shall not be liable for any
problems arising due to the product not
being earthed in accordance with the
local regulations.
•
Disconnect the appliance from the
electric connection before starting any
work on the electrical installation. Risk
of electric shock.
•
The appliance may only be connected
to the mains electricity connection by
an authorized and qualified person.
The manufacturer shall not be held
responsible for any damages that
may occur as a result of operations
performed by unauthorized persons.
•
The appliance must be installed
in a way that it can be completely
disconnected from the mains supply.
The disconnection shall be provided
by a switch built into the fixed
electrical installation, according to the
construction regulations.
•
The bottom surface of the cooker
gets hot, too, when it is in use.
Electrical connections shall not contact
the bottom surface, otherwise the
connections may be damaged.
•
Do not pass the connection cables
over the hot surfaces. Otherwise, cable
insulation may melt and cause fire as
a result of short circuit of the cooker. If
the electric cable is damaged, it must
be replaced by a qualified electrician.
Otherwise there is a risk of electric
shock, short circuit or fire hazard!
•
While performing the wiring, you
shall comply with the national/local
20
electrical regulations and shall use the
appropriate socket outlet/line and plug
for the cooker. In case the product's
power limits exceed the current carrying
capability of plug and socket outlet/
line, the product must be connected to
the fixed electrical installation directly
without using plug and socket outlet/
line.
•
Make sure that fuse rating is compatible
with the product.
•
Connection must comply with national
regulations.
•
The mains supply data must
correspond to the data specified on
the type label of the product. You may
see the type label on the bottom of the
cooker.
•
Power cable of your product must
comply with the values presented in
"Technical specifications" section.
•
If the appliance shall be directly
connected to the mains: If it is not
possible to disconnect all poles in the
mains supply, a disconnection unit with
at least 3 mm contact clearance (fuse,
line safety switch, contactor) shall be
connected and all the poles of this
disconnection unit shall be adjacent to
(not above) the appliance in accordance
with IEE directives. Failure to obey
this instruction may cause operational
problems and invalidate the product
warranty.
•
Additional protection by a residual
current circuit breaker is recommended.
If your appliance has a cord and plug:
•
Perform the electrical connection of
your appliance by plugging it to a
grounded socket.
If your appliance has a cord, but does
not have a plug:
•
Connect your appliance to the
mains as specified below as per the
cord type. The cord type of your
appliance is specified in the "Technical
Specifications" section of the operation
manual.
Advertisement
