Dashboard Mounting; Connecting The Power; Replacing The Fuse - Crunch 2160 Operation Manual

Dashboard mounting

7. Select an area relatively level, clean, and dry. Adhere
one
part of the enclosed hook-and-loop fastener to this area
and the other part to the bottom of the unit.
8. Fasten the unit to the area by placing the hook-and-loop
pieces together.

Connecting the Power

The detector is designed to operate on most DC12V
negative ground vehicle electrical systems. The power cord
provided with the detector has a cigarette lighter socket plug
at one end and a small connector at the other.
1. Insert the small connector into the jack on the side of the
detector.
2. Insert the other end into the cigarette lighter socket of
your vehicle.
If the detector does not operate when you turn it on, remove
the adapter from the cigarette lighter socket and carefully
check the socket for debris. Also, check the fuse in the
adapter and your vehicle's fuse box.

Replacing the Fuse

If the detector CRUNCH stops operating, the fuse in the
cigarette lighter plug might be blown. If it has blown, follow
these steps to replace it:
1. To replace the fuse, unscrew the top of the plug.
2. Remove the fuse and check the fuse to see if it has
blown. If it has, replace it.
24