List Of Messages - Canon VIXIA HV30 Instruction Manual

List of Messages

Some error messages will disappear after being displayed for about 4 seconds.
Message
SET THE TIME ZONE,
DATE AND TIME
CHANGE THE BATTERY
PACK
THE TAPE IS SET FOR
ERASURE PREVENTION
REMOVE THE CASSETTE
CHECK THE HDV/DV
INPUT
(Appears only if a DV cable is
connected)
CONDENSATION HAS
BEEN DETECTED
CONDENSATION HAS
BEEN DETECTED
REMOVE THE CASSETTE
TAPE END
INCORRECT TAPE
SPECIFICATION
INPUT SIGNAL NOT
SUPPORTED
PLAYBACK STD LOCKED
INCOMPATIBLE VIDEO
INPUT
PLAYBACK STD LOCKED
PLAYBACK IS
RESTRICTED
HEADS DIRTY, USE
CLEANING CASSETTE
NO CARD
NO IMAGES
CARD ERROR
CARD FULL
You have not set the time zone, date and time. This message
appears each time you turn the power on until you set the time
zone, date and time.
Battery pack is exhausted. Replace or charge the battery pack.
Cassette is protected. Replace the cassette or change the position
of the protect switch.
Camcorder stopped operating to protect the tape. Remove the
cassette and reinsert it.
The DV cable is not correctly connected to the HDV/DV terminal, or
the connected digital device is turned off.
The video input signal is in a different television system (PAL or
SECAM).
Condensation has been detected in the camcorder.
Condensation has been detected in the camcorder. Remove the
cassette.
Tape reached the end. Rewind the tape or replace the cassette.
You attempted to play back a tape recorded in a different television
system (PAL or SECAM) or in a recording standard not supported
by this camcorder.
The digital device connected with the DV cable is incompatible with
the camcorder.
Current camcorder settings do not match the HDV/DV standard of
the video input signal. Change the [PLAYBACK STD] setting to
match the video input signal.
Current camcorder settings do not match the HDV/DV standard of
the recording you tried to play back. Change the [PLAYBACK STD]
to match the recording standard of the tape.
Video heads are dirty. Clean the video heads.
There is no memory card in the camcorder.
No images are recorded on the memory card.
A memory card error occurred. The camcorder cannot record or
display the image.
The error may be temporary. If the message disappears after 4
seconds and " " flashes red, turn the camcorder off, remove the
card and reinsert the card. If "
can continue recording/playback.
Memory card is full. Erase some images to free some space or
replace the memory card.
Explanation/Solution
" changes to green or yellow, you
Trouble? 89
24
18
93
20
67
–
95
95
–
–
–
40
40
95
20
–
–
65