Troubleshooting Guide - Canon EOS Rebel T3 18-55mm IS II Kit Instruction Manual

Troubleshooting Guide

If a problem occurs with the camera, first refer to this Troubleshooting
Guide. If this Troubleshooting Guide does not resolve the problem,
contact your dealer or nearest Canon Service Center.
Power-Related Problems
The battery pack does not recharge.
Do not recharge any battery pack other than a genuine Canon Battery
Pack LP-E10.
The battery charger's lamp blinks.
If there is a problem with the battery charger, the protective circuit will stop
the charging operation and the charge lamp will blink in orange. If this
happens, disconnect the charger's power plug from the power outlet and
remove the battery pack. Attach the battery pack to the charger again and
wait a while before connecting the charger to a power outlet again.
The camera does not operate even when the power switch is set to <1>.
Make sure the card/battery compartment cover is closed (p.28).
The battery is not properly installed in the camera (p.28).
Recharge the battery (p.26).
Press the <B> button (p.46).
The access lamp still blinks even when the power switch is set to <2>.
If the power is turned off while an image is being recorded to the card,
the access lamp will still continue to light/blink for a few seconds.
When the image recording is completed, the power will turn off
automatically.
The battery becomes exhausted quickly.
Use a fully-charged battery pack (p.26).
The rechargeable battery pack performance will degrade over
repeated use. Purchase a new one.
242