Setup Using A Smart Device Connected Using Simpleap - Epson TM-L100 Setup Manual

Hide thumbs Also See for TM-L100:

Table of Contents

Setup Using a Smart Device Connected Using SimpleAP

Use SimpleAP to connect the printer to your smart device, and then use Epson TM Utility to set the network

connection.

Prepare the following items.

• Smart device: iOS 12 or later/Android 8 or later

• Setup utility: Epson TM Utility

• Wireless LAN unit: OT-WL06

Follow the procedure below to set the network connection.

* In this manual, iOS is used to describe this procedure. The procedure is the same for both iOS and Android.

Connect the wireless LAN unit (OT-WL06) to the printer.

Turn on the smart device.

Start the printer in the SimpleAP mode.

If the wireless LAN connection is set to the default values (factory default), it will automatically start

in SimpleAP mode when the power is turned on and print the following.

If this is not printed as shown here, see

SimpleAP Start

SSID

: DIRECT-TM-L100- XXXXXXXXXX

Encryption Type : WPA2-PSK

Passphrase

: XXXXXXXXXX

IP Address

: 192.168.192.168

MAC Adress

: XX-XX-XX-XX-XX-XX

"Starting SimpleAP" on page 30

for more information.

Table of Contents