smart home The Hub Installation Manual page 6

Add Z-Wave devices to
the Smart Gateway
(automation accounts)
To add Z-Wave devices locally using the buttons
on the device:
1 Press and release the Z-Wave button located on the
side of the Smart Gateway to put it into Add mode.
The Z-Wave LED will begin blinking slowly.
2 Trigger a device to add it to the network. (Refer to
the device's installation documentation.) The Z-Wave
LED on the Smart Gateway will begin blinking
quickly as the device is being added.
3 When a device is added successfully, the Z-Wave
LED on the smart gateway will remain solid
for 15 seconds.
4 Repeat this process to add additional Z-Wave devices.
5