Broan PMA400SS Installation, Use & Care Manual page 11

PREPARE THE UNIT
a
ll installations
1 . If present, remove all protective polyfilm from the unit and/
or parts .
2 . Remove the grease filter by pushing down on latch tab and
tilting the filter downward (FIG . 16) . Set aside the filter .
3 . Disassemble the electrical compartment cover (grey part
in FIG . 17) from inside the unit by removing its retaining
screw . Remove the parts bag behind the cover . Set aside
the parts bag and the cover along with its screw .
4 . Punch out both knock-out holes . Install an appropriate
7/8" diameter strain relief (not included, grey parts in
FIG . 18) in each hole .
NOTE: The HCK44 cord connection kit (optional) can
be used instead of the house power cable . Refer to the
instruction packed with the HCK44 cord connection kit .
h
orizontal exhaust installation only
5 . Unplug the blower cable from its connector on faceplate .
Disassemble the faceplate from the unit by removing its
4 retaining screws (two per side, circled in FIG . 19) . Set
aside the faceplate along with its screws .
6 . Remove the 4 screws (two per side) retaining the blower
support plate to the top of the unit (FIG . 20) . Carefully lift
out and set aside the blower with its support plate . The
blower will be reinstalled later in the unit .
HD1345
HD1349
HD1414
HD1359
SCREWS
HD1360
FIG. 16
SCREW
FIG. 17
FIG. 18
FIG. 19
SCREWS
11
FIG. 20