Cambridge Audio AXR85 Manual page 7

Note: There will be no sound from the receiver if the correct input source button isn't selected.
6. PRESET BUTTONS - Used for AM/FM modes. The preset buttons are used to select user-stored station presets.
Pressing a preset button once will select one of the first 5 presets.
Pressing and holding will select the later 5 presets.
These presets are stored separately for each waveband i.e. there are 10 for FM and 10 for AM. Press the FM/AM button to switch between
bands and sets of 10 presets.
Follow the 'Storing Radio Presets' guide in the 'Operating Instructions' section for full details on storing presets.
Note: As well as these 10 per band available directly from the front panel buttons, a further 5 presets (11-15) per band can also be accessed by
using the 'Skip/Scan' buttons to cycle through all 15 presets.
7. DISPLAY - Used to display information such as the selected input source, volume and tone/balance levels. When the FM or AM tuner input is
selected, the radio frequency or RDS station name will be displayed.
Note: When first purchased, the display will have a protective film over the top. Peel this off for a clear display.
8. SPEAKER A/B BUTTON - The Speaker A/B button toggles between the two sets of loudspeaker terminals. The options are speaker A only,
speaker B only, speaker A and B together, and both sets of speakers off.
Note: 'Speaker off' is different to the mute function, as the Rec Out and Headphones outputs are still enabled.
9. MENU BUTTON - Pressing this once will select the Bass option. Pressing a second time will select the Treble option and pressing a third time will
select the Balance option. When one of these options is selected, the volume control will adjust the level.
If nothing is pressed for a while, the source will be displayed and the volume control will go back to controlling the volume level.
Note: Any adjustments to the Bass, Treble and Balance settings are saved when the unit is switched off and back on again.
10. INFRARED SENSOR - Receives IR commands from the supplied remote control. An unobstructed line of sight between the remote control and
the sensor is required.
11. VOLUME CONTROL - Use to increase or decrease the level of the sound from the outputs of the unit.
This controls the volume level of the loudspeakers, Sub-out and headphones.
Note: It does not affect the level of the 'Rec Out' output, as this has a fixed level.
The volume control will also change the level of bass, treble and balance in the menu options.
12. AUX INPUT SOCKET - This source input allows you to connect a portable audio device, such as a smart phone, directly into the front of the unit
using a 3.5mm stereo-jack. Once plugged in, this input is automatically selected.
7