Download Print this page

Pro-Elec PELL0212 Manual page 4

Oil filled heater

Advertisement

Switch I is for low heat, switch II for medium heat and turn both switches on for
high heat. When the heating element is on the power switch will illuminate.
When your room reaches the desired temperature, slowly rotate the thermostat
control counter clockwise until the power light goes out. The thermostat can now
be left at this setting. As soon as the room temperature has dropped below the set
temperature, the unit will switch it self on automatically until the set temperature
has been reached again. In this way the room temperature remains constant with
the most economical use of electricity.
If you want to change the room temperature setting, rotate the thermostat knob
clockwise to raise the temperature, or counter clockwise to lower it.
USING THE TIMER
The timer has a small red switch, the function is as follows: I=Heater is under
manual control or
Set the timer to
around the timer, each correspond to 15 minutes interval.
When the pins are set outward the heater will be ON and
when set inwards the heater will be turned OFF.
CAUTION: Do not use the timer function unattended.
The heater will not operate if timer if set to the
the pins have not been set accordingly or the thermostat is set too low.
If the heater looses its electricity supply, e.g. switched off at the mains socket or in
the even of a power failure, the time should be reset after the power on again.
CLEANING AND MAINTENANCE
Always remove the plug from the mains socket and allow the radiator to cool down
before cleaning the heater.
Wipe the radiator with a soft damp (not wet) cloth.
Do not use any cleaning chemicals such as detergents and abrasives.
SPECIFICATIONS
Model
Rated Voltage
Frequency
Rated Power
Auxiliary electricity consumption
At nominal heat output el
At minimum heat output el
In standby mode el
With mechanical thermostat room temperature control plus day timer
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
This product is only suitable for well insulated spaces or occasional use.
=Timer function is ON.
position. There are 96 small plastic pins
PELL0211 & PELL0212
220-240VAC
50Hz
1500W
max
min
sb
As is typical for all portable heaters -
position but
Heat Output
Nominal heat output P
Min heat output P
min
Max heat output P
max
0,7001kW
nom
0kW
0,7001kW
0kW
0kW
N/A
YES/YES
Made in China
PO Box 13362 Dublin 2
PR2 9PP
Man Rev 1.1

Advertisement

loading

This manual is also suitable for:

Pell0211Pell0212-uk