Makita EA5001P Operator's And Safety Manual page 15

3
WARNING!
There is an extreme danger of kickback at this point.
Extra caution must be taken to maintain control of
the saw. To make the felling cut, follow the sectioning
method described previously (fig. 29).
If you are inexperienced with a chain saw plunge-
cutting should not be attempted. Seek the help of a
professional.
Limbing
Limbing is removing the branches from a fallen tree.
WARNING!
There is an extreme danger of kickback during the
limbing operation. Do not work with the nose of the
bar. Be extremely cautious and avoid contacting the
log or other limbs with the nose of the guide bar.
Do not stand on a log while limbing it - you may slip
or the log may roll.
Start limbing by leaving the lower limbs to support
the log off the ground (fig. 30). Always cut from the
top of the limb.
Do not underbuck freely hanging limbs. A pinch may
result or the limb may fall, causing loss of control.
If a pinch occurs, stop the engine and remove the
saw, by lifting the limb.
WARNING!
Be extremely cautious when cutting limbs under
tension. The limbs could spring back toward the
operator and cause loss of control of the saw or
injury to the operator.
Bucking
Bucking is cutting a log into sections.
2
29
1
1. When bucking, do not stand on the log. Make sure
2. Cut only one log at a time.
3. Shattered wood should be cut very carefully. Sharp
30
4. When cutting small logs, use a sawhorse (fig. 32).
WARNING!
the log will not roll down-hill. If on a slope, stand
on the up-hill side of the log (see fig. 31). Watch
out for rolling logs.
WARNING!
WARNING!
slivers of wood may be caught and flung in the
direction of the operator of the saw.
WARNING!
Never permit another person to hold the log. Never
hold the log with your leg or foot.
At the end of the cut the weight of the chain saw
will cause it to swing through, since it is no longer
held by the cut. Hold it firmly to control this.
31
32
15