Table of Contents
Advertisement
28
Chapter 2: Unpacking and installing the workstation
BenchCel Microplate Handling Workstation R-Series User Guide
Installation workflow
About this topic
Workflow
Related topics
This topic presents the workflow for unpacking the BenchCel device
and installing the BenchCel Workstation.
The following table presents the steps for unpacking and installing the
BenchCel Workstation.
Step
For this task...
1
Verify laboratory
requirements.
2
Unpack and inspect the
BenchCel Workstation.
3
Integrate external devices.
4
Connect the power.
5
Connect the pendant.
6
Connect the air supply.
7
Connect the computer.
8
Install the safety shield.
9
Install the BenchWorks
software.
For information about...
Installing external devices
Setting up the BenchCel
Workstation
BenchWorks software
Writing protocols
See...
"Verifying laboratory requirements"
on page 29
"Unpacking and inspecting the
BenchCel device" on page 32
"Integrating the devices" on page 35
"Connecting the power source" on
page 39
"Connecting the pendant" on
page 40
"Connecting and disconnecting the
air source" on page 41
"Connecting the computer" on
page 44
"Installing the safety shield" on
page 47
BenchWorks Automation Control
User Guide
See...
External device user documentation
"Setting up the BenchCel Workstation"
on page 49
BenchWorks Automation Control User
Guide
BenchWorks Automation Control User
Guide
Advertisement
Table of Contents
