TO THE OWNERS GENERAL COMMENTS Congratulations for having this Forestry Mulcher! Your Forestry Mulcher was carefully designed and manufactured to give you years of dependable service. Your Forestry Mulcher will require some minor maintenance to keep it in top working condition. Please observe all safety precautions and maintenance procedures as described in this manual.
SAFETY PRECAUTIONS BEFORE OPERATION 1. The operator must read the operation manual carefully before installation, operation or maintenance. Improper operation will cause the machine damage or the operator death. 2. Read all the safe signs and safe declarations. Follow all the professional safe terms, local laws or the professional directions.
OPERATION INSTRUCTIONS b. Do Not Allow Riders i. Never lift or carry anyone on the mulcher. ii. Never use mulcher as lift platform or to carry passengers. c. Drive Slow and Avoid Rollover i. When traveling forward, keep mulcher low to ground on rough and uneven terrain.
Page 19
OPERATION INSTRUCTIONS i. Pre-Operation Checklist. It is the operator’s responsibility to perform the following checks prior to operations of mulcher: i. Verify all hardware is tightened. ii. Inspect hoses and fittings for wear, damage, and leaks. Replace damaged or leaking hoses before use. iii.
Page 20
OPERATION INSTRUCTIONS k. Operation Procedures: i. Test functions in clear, open area with skid steer in idle. Understand controls of machine before using at full speed onbrush/trees. Starting Mulcher: 1. Lower the mulcher so skid plates are grounded. 2. Slowly engage mulcher at low idle, and increase mulcher drum to approximately half speed (1000 RPM).
Page 21
OPERATION INSTRUCTIONS v. If mulcher is stalling: Stop forward movement, raise mulcher, and allow rotor to regain full speed. Also recommended to slow your forward ground speed to help prevent stalling. vi. If mulcher completely jams: Disengage hydraulics, lower to ground, and stop skid steer engine.
Page 22
OPERATION INSTRUCTIONS Maintenance Continued Belt Pulley Grease Point sales@agrotkindustrial.com https://www.agrotkindustrial.com/...
Page 23
OPERATION INSTRUCTIONS Drum Bearing Access Point - Remove plug and breather. - Fill with gear oil until there is oil coming from fill level hole (85W/90GL-5). - Replace plug and breather. sales@agrotkindustrial.com https://www.agrotkindustrial.com/...
Page 24
OPERATION INSTRUCTIONS Motor Access Point - Remove plug and breather - Fill until oil is coming from fill level hole(85W/90GL-5) - Replace plug and breather sales@agrotkindustrial.com https://www.agrotkindustrial.com/...