b.
To insert the new battery, slide one edge of the replacement battery under the holder's lip with
the positive side up. Push the other edge down until the clamp snaps over the other edge of
the battery (2).
Figure B-2
Type 3
a.
Pull back on the clip (1) that is holding the battery in place, and remove the battery (2).
b.
Insert the new battery and position the clip back into place.
Figure B-3
NOTE
procedure.
9.
Replace the access panel.
10.
If the computer was on a stand, replace the stand.
11.
Reconnect the power cord and turn on the computer.
ENWW
Removing and Replacing a Coin Cell Battery (Type 2)
Removing a Coin Cell Battery (Type 3)
After the battery has been replaced, use the following steps to complete this
33