Troubleshooting - Duramaxx 85729 Owner's Manual

TROUBLESHOOTING

Problem
Handle not in position.
Mower not starting.
Mower cutting grass unevenly.
Mower not mulching properly.
Mower hard to push.
Mower vibrating at higher speed.
Possible Cause
Carriage bolts not seated properly.
Handle knobs not tightened.
Battery is low in charge.
Battery is either defective or will not
take a charge.
Lawn is rough or uneven or cutting
height not set properly.
Wet grass clippings sticking to the
underside of the deck.
High grass, rear of mower housing
and blade dragging in heavy grass,
or cutting height too low.
Blade is unbalanced.
Bent motor shaft.
29
Solution
Adjust the height of the handle and
make sure the carriage bolts are
seated properly.
Tighten handle knobs.
Charge the battery.
Replace the battery.
Move the wheels to a higher position.
All wheels must be placed in the same
cutting height for the mower to cut
evenly.
Wait until the grass dries before
mowing.
Raise cutting height.
Balance the blade by grinding each
cutting edge equally.
Stop the motor, disconnect the power
source, and inspect for damage. Have
repaired by an authorized service
center before restarting.