Indoor Unit Installation Diagram - Daikin FTX09NMVJUA Installation Manual

Indoor Unit Installation Diagram

A Mounting plate
B
Mounting plate
fixing screw
3/16" × 1" (M4 × 25mm)
Front panel
1-15/16" (50mm) or more
from walls (on both sides)
Air filters
C
Titanium apatite deodorizing filter (2)
09/12 class
Titanium apatite deodorizing filter
15 class
Filter frame
Titanium apatite
deodorizing filter
Tab
Claw
■
English
The A mounting plate
should be installed on a
wall which can support the
weight of the indoor unit.
1-3/16" (30mm) or more from ceiling
Screws
3/16" × 5/8" (M4 × 16mm)*
*The 15 class model has 3 screws.
The service lid is removable.
Opening method
1) Remove the service lid screw.
2) Pull out the service lid horizontally in
the direction of the arrow.
3) Pull down.
D
Wireless remote
controller
Air filter
How to attach the indoor unit
Hook the hooks of the bottom frame
A
to the mounting plate.
If the hooks are difficult to hook,
remove the front grille.
How to remove the indoor unit
Push up the marked area (at the
lower part of the front grille) to
release the hooks. If it is difficult to
release, remove the front grille.
Front grille
Caulk pipe hole gap
with putty.
Appearance of
indoor units may
differ from some
models.
(This is a 09/12
class illustration)
Service lid
F Fixing screw for remote
controller holder
1/8" × 13/16" (M3 × 20mm)
A
Mounting
plate
Hook
Bottom frame
Mark (rear side)
Wrap with the finishing
tape so that no gap is left.
Wrap the insulation pipe with
the finishing tape from bottom
to top.
Before screwing the
remote controller
E
holder to the wall, make
sure that control signals
are properly received by
indoor unit.
E
Remote
controller holder
4