Installing An Internal 3.5-Inch Hard Drive - HP Compaq 6005 Pro MT Hardware Reference Manual

Installing an Internal 3.5-inch Hard Drive

NOTE: The system does not support Parallel ATA (PATA) hard drives.
1. Remove/disengage any security devices that prohibit opening the computer.
2. Remove all removable media, such as compact discs or USB flash drives, from the computer.
3. Turn off the computer properly through the operating system, then turn off any external devices.
4. Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
long as the system is plugged into an active AC outlet. You must disconnect the power cord to
avoid damage to the internal components of the computer.
5. Remove the access panel.
6. Install the four guide screws (two on each side) that were removed from the old drive into the new
drive. The screws help guide the drive into its proper position in the bay. Extra guide screws are
provided on the exterior of the hard drive bays.
Figure 2-30
NOTE:
installed on the exterior of the hard drive bays. The HP-supplied isolation mounting guide screws
are silver and blue. Refer to
extra 6-32 isolation mounting guide screws location.
If you are replacing a drive, transfer the guides screws from the old drive to the new one.
ENWW
Regardless of the power-on state, voltage is always present on the system board as
Installing Hard Drive Guide Screws
The hard drive uses 6-32 isolation mounting guide screws. Four extra guide screws are
Installing and Removing Drives on page 23 for an illustration of the
Installing and Removing Drives 35