HP Brio 8200 User Manual page 59

Regulatory and License Information
Regulatory Information
Ensure that only equipment having connection points with the same safety status as identified above is connected to each individual
interconnection point provided by the HP PC communications board.
Always disconnect the host PC from the power supply before removing the cover.
Always disconnect the host PC from any analog telephone circuits before removing any covers.
Failure to install the HP PC communications board in accordance with the instructions provided above will invalidate the approval.
If you have any doubt as to how to safely install the HP PC communications board correctly within a host chassis, please seek advice from a
qualified telecommunications engineer.
Power Consumption of the Communication Card
5V: 340 mA max.
12V: 47mA max.
General Information
Communications Board
The communications card complies with the European Directive 91/263/CEE.
Type Approval Information
The HP PC communications board has been approved for connection to telecommunications systems specified in these instructions for use, and
is subject to the conditions set out in them.
The HP PC communications board has been approved for connection to the Public Switched Telephone Network.
The HP PC communications board is suitable for household, office and similar general indoor use.
The HP PC communications board is not suitable for use as an extension to a payphone.
The HP PC communications board must only be used on telephone lines which provide multifrequency (DTMF) dialing.
Please be aware that it is the HP PC communications board which has been approved, and not the host computer in which it is installed.
There are no adjustments available to the user which could cause the HP PC communications board to no longer conform with the type approval
requirements applied by BABT
For U.S. Only
Notice Regarding the Connection of Telephone Equipment to Telephone Lines
This equipment complies with Part 68 of the FCC Rules. Provided with this equipment is a label that contains, among other information, the
FCC Registration Number and Ringer Equivalence Number (REN) for this equipment. You must, upon request, provide this information to your
telephone company.
The REN is used to determine the quantity of devices you may connect to your telephone line and still have all of those devices ring when your
telephone is called. In most, but not all areas, the sum of the RENs connected to one line should not exceed five (5). To be certain of the number
of devices you may connect to your line, as determined by the REN, you should contact your local telephone company to determine the
maximum REN for your calling area.
If your telephone equipment causes harm to the telephone network, the telephone company may discontinue your service temporarily. If
possible, they will notify you in advance. But if advance notice is not practical, you will be notified as soon as possible. You will be informed of
your right to file a complaint with the FCC.
Your telephone company may make changes in its facilities, equipment, operations or procedures that could affect the proper functioning of
your equipment. If they do, you will be notified in advance to give you an opportunity to maintain uninterrupted telephone service. This product
contains no user serviceable parts or assemblies.
51